Where is the camshaft postion sensor located on a 1997 plymouth breeze

Change crankshaft sensor.

Was one part that got replaced even tested &
failed a test?

There are four parts you mentioned
I would bet none were bad

Now how does someone guess without the car
& no testing of your vehicle,how is that possible?

Have you checked for spark,injector pulse,fuel pressure,
or compression??

Have you looked to see if the timing belt is on or the cams
even turn?

Sounds like lack of experience & I don't mean to be hurtful,
but when you throw parts at something, you need to learn how
things work & how to test a vehicle

If you have the 2.0 SOHC the sensor will be on the right side(driver side) of the valve cover just underneath all those wires from the wire harness and power brake booster hose are. I found it easy to unplug some of the connectors and GENTLY push them out of the way to gain clear access to the camshaft position sensor, the Temprature sensor is just to the left of it ,unplug that and then unplug the camshaft sensor . the cam sensor is held in place by four ten mm bolts. Don't forget to put a new oil seal on the new sensor .or else you'll have oil spewing out from that side of the engine!

Yes, I had this on my 97 Stratus....could be a couple of things....one, the there may be damage to the wire connector harness going to that sensor. That was the problem with mine. I replaced the cam sensor, crank sensor, coil pack, mas sensor..etc...it ended up being a burnt spot on the wire harness. They said this is a common problem for the stratus/breeze/cirrus/intrepid.....the most it could be is a bad ECM....there is a bad pin on it located half way down the side where the big connector is. It is the silver block with the big wire harness going to it in the engine compartment. Try wiggling that around...the harness area.

You need battery power for the computer to fuction, so yea get the battery charged up first.

If you mean the Crankshaft position sensor, it is located within the distributor and is quite easily replaced.

It is on the rear of the engine next to/under the camshaft sensor.

SCAN IT LOOKS LIKE CAMSHAFT POSITION SENSOR.OR OTHER INTERNAL PROBLEMS IN DISTRIBUTOR.LIKE THE RESISTOR.

If i remember, it's located near the passenger side of the car behind the oil filter. There should be 4 screws holding it in place in a square pattern, 1 in each corner and the size is around 5mm.

Hope this helps.

what is a crank position sensor ,what does that do ..