Hi. Thanks for your question. For Torque specification for engine of model 2KD-FTV Toyota you can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!
SOURCE: torque specs for toyota tercel
Hello vienotkelly: The correct Main bolt torque is 42 foot pounds. The connecting rods torque to 29 foot pounds. The torque sequence for the head bolts and the correct way to tighten the bolts are attached to this reply. Thak You for using FixYa. Roger
SOURCE: whats the valve clearance for toyota 4k engines
valve clearance is .20mm for the intake and .30mm for the exhaust. Will try to find cylinder head torque for you.
SOURCE: What is the right Torque Specification of the
Cylinder heat bolt torque:
Torque sequence --------- front | 7 3 1 5 | | 8 4 2 6 | --------- Step 1: Torque all bolts in sequence to 14 Ft/Lbs Step 2: Torque all bolts in sequence to 29 Ft/Lbs Step 3: Torque all bolts in sequence to 36 Ft/Lbs Step 4: in the sequence, loosen the cylinder head bolts three turns. Step 5: Tighten short bolt to 15 - 32 Ft/Lbs Step 6: Tighten long bolt to 30 - 36 Ft/Lbs Step 7: Tighten all bolt to 175- 185 degree note: Do not loosen all of the cylinder head bolts at one time. Each cylinder head bolt must be loosened and the final tightening prior on the next bolt in the sequence.
Main bearing torque:
Torque sequence: Step 1: torque bolts to 91 Ft/Lbs with the exception of the rear main bearing cap Step 2: torque rear main bearing cap bolts to 88 Ft/Lbs Step 3: torque brace bolts to 40 Ft/Lbs
Connecting rod torque:
Torque sequence Step 1: Torque to 29 Ft/Lbs Step 2: Turn an additional 90 degrees
SOURCE: how to reset timing belt
usually 2 options to reset toyota light.
1.remove small rubber plug in dash clear lense.use a long thin rod to reach in and push the small reset button at the bottom of the gauges.Light will extinguish.
2.remove the instrument panel and unplug all from behind to turn it over.Usually in the centre of the rear you will see two holes and 1 screw.for t-belt.shift the screw to other hole.refit dash ensuring all the plugs are refitted.Light should now be out.
3,258 views
Usually answered in minutes!
×