SOURCE: replaced in/tank fuel pump.
I have had problems with my 89 prelude. I found that the problem wasn't with the fuel pump, rather the master relay. You will have voltage at the fuel pump with the fuel pump dicconnected, but when you connect the pump and put a electrical load on the circuit, the voltage drops. check current with the pump running and see if this is the case.
SOURCE: The tachometer on my 92 Honda Prelude Si works but the factory speedometer isn't whatsoever.
Its probably your speed sensor mounted on the back side of your transmission on top of the final drive gear. Its the sensor/plug located just under the shift linkage. Make sure its bolted down tight and check for any loose connections.
SOURCE: speedometer on 92 honda prelude si
no there is no easier way if he didnt put the pin to the cable back on it must be reattached
SOURCE: where is the selinoid located (cyllinoid?) in a
The solenoid is on or in the starter depending on if the car has a mitsuba or a nippondeso starter.The mitsuba has to be replaced,the nippo can be repaired with a new set of contacts and a plunger.They are both located on the passenger side and can be found by following the positive cable to the starter.
SOURCE: Torque specs for head bolts, 1990 Honda prelude si
49lbs I believe but it should tell you in the manual or goto a Kragen store and just flip thru a Haydem or Chilton repair book real quick.
38 views
Usually answered in minutes!
×