Car runs fine then when it warms up or idles to long it dies sounds like its gasping for air then wont start for about 30 min then runs fine again

Sounds like dirt in the carburator, or the filter if it has one

How many rpm's is it running at when you first start it up and it is running on the choke? Does it gradually start to idle back and then start to die r does it do it all of a sudden and dies?

When running with the choke on, it is on the high idle circuit of the carb, as it warms up the idle should slow down and then idle in the 800 rpm range in Park, 650 in Drive. This will be the low idle circuit range. This transition inside the carb will cover an idle air bleed hole in the venturi of the carb and lean out the mixture. If you notice that the carb smells gassy and black rich unburnt gases are coming from the tailpipe, the problem is located within the carb and requires a carb tech to do a rebuild of the carb. You could try a good carb cleaner like Lucas by putting it into the gas tank, in case you just got a bad tank of gas, but that is just a bandaid for a more deeply rooted problem. Get the carb rebuilt?

Vapor lock again! Make sure the fuel lines are away from hot surfaces, or insulated.
Also, when it warms up, the automatic choke turns off, and the idle setting has to be set to run at that temp. There will be idle jets, maybe two, and idle stop setting for the linkage.

Hi, This sounds like the fuel pump needs replacing. Please leave me feed back: Malcolm Campbell, Thanks.

egr passage plugged, for sure..

Engine stalls or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

you may not have the fuel lines sealed, they can **** in air without leaking fuel, especially in the tank, whre the pump connects

It sounds like there is a problem with the Idle Air Control (IAC) valve. Its job is to open and let air into the manifold when the throttle is closed at idle. If it does not open, the engine dies at idle. The IAC is mounted on the throttle body. Possibly the valve is clogged or stuck, in which case it could be ok again if it is removed and cleaned. Or it is broken, and needs to be replaced. Or, there is a problem with its electrical connection, that needs to be traced. Good luck, let me know if you have any questions.

try the control module

Sounds like the fuel filter is dirty and needing to be changed. It's cheap and easy to swap out.