SOURCE: 2000 hyundai accent
Their shop website says below but you can call the service department. usually you want to tighten it just until it starts to not rotate freely then back off just a little bit. It should spin freely.
Hub bearing starting torque [Limit] :
1.8 Nm (18 kgf·cm, 1.33 lbf·ft) or less
SOURCE: Broken Hyundai 2002 Accent door handles
i have a 2005 hyundai both back doors would not open from the outside . after taking the panel off i found out that the handle is completely plastic and that it had broke in half because off stress . i removed the handle ( which was a pain ) and used quick drying epoxy on the crack . then i put a thin piece if aluminum on each side of the crack and used the same epoxy to hold it on . the next day i put the handles back on ( after letting the epoxy dry ) and it has worked perfect ever since. my next recourse , if it breaks again , is go to ebay . there is a seller if you type in hyundai door handles that sells 2 after market ones for $39.99. they fit 2001 to 2005 . i hope that this helps .
SOURCE: 2006 Hyundai sonata trunk doesn't lock the hood
I had to reinstall the loose mounting hardware for the trunk upper latch.
SOURCE: driver's side door latch wont open door from inside
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
143 views
Usually answered in minutes!
×