Ok first of all I have been an auto mechanic for years so im actually just looking for a quick fix. So ill tell ya what i've all ready tried.My air bag did deploy. And the fuel shutoff switch was not triggered. So i do not need to push the fuel reset switch. Now what i am wondering is if maybe a relay or maybe the lick itself just may have torn up the fuel pump?? I am going to turn on my key and make sure i have power to the fuel pump wires next. If i do i will know i just need a fuel pump.But honestly the only thing i can think of is if the airbag deploying caused this by shutting something off like a relay or if the impact just tore the fuel pump up internally
SOURCE: Ford Focus seatbelt locked
There is a gas cylinder that tightens the belt in a minor collision, it is a one time use part it is independent of the air bag deployment system, you will have to replace the seat belt gas cylinder, that may mean a new belt assembly, not sure on focus.
SOURCE: Removing air bags from 2001 Ford Windstar
easy fix.
the drivers airbag comes with the steering wheel. To remove it, snap off the plastic cover at the bottom of the steering wheel. there will be a screw which you need to remove. You will be unscrewing it for quite some time and the wheel will only wobble but eventually it will come off. Disconnect the wires. To replace, put the new steering wheel on trying to align the pin and screw it back in. don't forget to connect the wire. To remove the passenger side, open the glove compartment, squeeze both sides of the back to let the glove compartment fully open. There are 3 nut that you need to remove and a wire. To replace, just do the opposite.
Most likely, you will have to replace the airbag control module also. On this particular year and model, it is located behind the storage compartment below the radio. To remove, unscrew 4 screws (2 on each side of the compartment), disconnect the 12v lighter plug and remove. The computer is located in the very back and has 3 nuts holding it down. There is an arrow on it pointing to the front of the vehicle. Remove the nuts, unplug the wires and get a computer which has the exact same code as yours.
Sometimes, (as was in my case) when the airbag went off, my seatbelts went off and locked in place. To replace, remove the plastic cover off of where the seat belt slides through (near the top of the door post) and unscrew the nut then remove/move aside the plastic trim and unscrew 1 bolt below the seatbelt roll and remove. The last bolt is located between the seat and door. Pick up the carpet and unscrew.
SOURCE: my fg 2008 falcon has been involved in a side
not sure if the module needs to be replaced may need to be if it got damaged but disconnect the battery for 10 min and reconnect and that should clear ant codes
SOURCE: I own a 2002 Ford Explorer. My air bag light
sometimes you can disconect battery for a few min. and computer will reset
SOURCE: no ignition after front collision 2004 f-250
wiring check should be done first (pin to pin) especially the wire leading to the crankshaft sensor behind the engine dumper pulley
91 views
Usually answered in minutes!
×