2005 mustang gt

mages for 4.6 Engine valve train in 2008 Ford Mustang Gt


More images for 4.6 Engine valve train in 2008 Ford Mustang Gt

2005-2009 Mustang Cylinder Heads & Valvetrain ...

www.americanmuscle.com/mustang-valvetrain-0508.html
They help your motor breathe better and also make sure your Mustang gives top-notch throttle response. ... 2005, 2006, 2007, 2008, 2009 Mustangs; V6, GT, Bullitt, Shelby GT500, ... 2005-2009 Mustang GT Cylinder Heads & Valvetrain Components ... (6).Ford Racing SOHC 3V 4.6L Head Changing Kit (05-10 GT) $76.00.

Mustang Camshaft Facts & Technical Information ...

www.americanmuscle.com/camshaft-tech-guide.html

check your coil packs or your ignition leads other than that if it continues change the plugs if it still happens take it to a mechanic sorry i couldnt be of more assistance

SORRY, I ALWAYS JUST PUT BLACK ELECTRICAL TAPE OVER THEM...NO EMISSIONS WHERE I LIVE

For engine misfiring problem check the help links mentioned below. Click the link below to go through the troubleshooting procedure :---- Engine misses and truck jumps? Hard to down shift? Issue with high gear only? http://technoanswers.blogspot.in/2012/02/engine-miss-and-truck-jumps-hard-to.html

-----------
Bad miss at idle?

http://technoanswers.blogspot.com/2012/01/bad-miss-at-idle.html

-----------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

------------
Engine Misfire codes for car?

http://schematicsdiagram.blogspot.com/2011/12/engine-misfire-codes-on-chevrolet.html
Engine Misfire codes?

http://schematicsdiagram.blogspot.com/2011/12/engine-misfire-codes-on-chevrolet.html

--------------
Misfire on cylinder 4?

http://schematicsdiagram.blogspot.com/2011/12/misfire-on-cylinder-4.html

-----------
Oil on spark plugs and car misfires?

http://technoanswers.blogspot.in/2012/02/oil-on-spark-plugs-and-car-misfires.html

----------

This will help.

Thanks.

Generally if the vehicle is running lean on one side the O2 sensor is bad. The oxygen sensor is normally located at the back of the exhaust manifold, and there is one on each side. It is best to replace both at the same time to save money and problems later on.

P0171 Means system is to lean on bank #1. P0174 Means system to lean on bank #2.

vacuum leak. it wiil cause a misfire code to be set because too lean from vacuum leak.

Clean the mass air flow sensor.

Try a fuel line/injector cleaner you may have a blockage affecting fuel flow causing the low (LEAN) fuel to bank one code. Raz,..

HI, i have the samme problemeon my mustang gt 2006
idid hevriting ,plug chek wires , and the probleme was the valve was sticking on the guide ,we change the head , and now it is very jood, good luck
it was misfiring whit no code