At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: 2002 Saturn SL 2 --- ignition sticking, have to leave...
YOU WILL NEED TO REPLACE THE IGNITION SWITCH. CAN USE GRAPHIET IN KEY THEN PUT INTO IGNITION THS WILL BUY YOU SOME TIME BUT ULTIMETLY YOU WILL NEED TO REPLACE IT
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check if security light is on, if so, must reset. To reset, put key in ignition and turn to on position. Security light will start flashing on and off. Leave key in on position until security light stops flashing and turns off completely. This will take approximately 10 minutes. Then turn key off and take out of ignition. Put key back in and start car. Should now start
u will need about 1/2 to do the flash ----insert key and turn to the on position [do not start] and leave in this position for ten minutes --the security light will flash and go on and off during this ignition flash ---then turn off for 10 seconds ====repeat this step 2 more times than turn key to on for a second than start vehicle ur key and ignition relearn should be complete
hello there: i would recommend to apowder graphite for the ignition switch instead of wd-40 to help keep the dirt from sticking as bad if that doesn't work you may want to invest in getting a new switch...hope this help you out please leave a review thanks sincerely D.Jones
Try to start the leve key on for 10 min, turn off (wait 10 sec) then try to start again and leve on for 10 min again, turn off and try again wait 10 min, turn off for 30 sec and then start engine.
did you give them the vin when you bought the ignition,it has to be the one for your car,also might have to relearn the key to the computer,turn key on try to start let go and leave in on position for 10 minuites turn off for 5 seconds,turn back on try to start let go leave for 10 minuites,turn off for 5 seconds ,repeat one last time,takes a little over 30 minuites,to complete,the car thinks your trying to steal it and is disableing the fuel pump
turn key from off to the on postiton. does the security light blink?
if so leave in on postition until light stops blinking (10min) then try to start car. may have to repeat process up to three times.
if the security re-learn process works, you will need a new ignition cylinder with security sensor. if not local gm dealer can tell you for sure.
PASS LOCK RESET GM CARS 1999 UP 1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key
×