Suzuki Vitara - Popular Questions, Answers, Tips & Manuals
1996 Suzuki Vitara with auto transmission.
A/t 96 vit. hot and gold engine;/trans both?
slow upshift.
the most common is this.:
- TV cable to box is jammed at any point of cable or kinked.
- low pump pressure in the box or filter in box pan clogged.
- scanning the TCM shows errors ignored? oops
- the OD lamp flashing odd , means TCM errors. so get them.
- normal is the shift lever, rocker switch (?N?P?) normal or power shift mode, power shift mode delays shifts for sure. so switch it back.
- internal transmission leaks can cause #2
- low (super) low tranny ATF (done hot,in park and engine running never overfill any box or use the wrong ATF. ask. first or read the glove box guide (IIRC,Dexron 3 to max #). RTM manual,
- if TCM sees speed error from speed sensors ,the VSS sensor at rear of tranny reads slow, the shifts will be late. speedsensors
Alternator problems
I have a suzuki
have the charging system checked by an accredited auto specialist shop
include a load test on the battery and drive belt tension and condition
indicates problem wiring or voltage regulator
Suzuki vitara91 model wont go into reverse
Either the clutch plates don't have sufficient clearance when the clutch pedal is pressed or they do have the clearance but are failing to separate.
Air in the hydraulic system, worn or maladjusted linkage or cable are the common causes of the first and oil/grease contamination or rusty splines the second scenario.
A failing clutch pilot bearing, if fitted, could also the symptom.
Hi I just bought a 1990 susuki vitara, the power
Flush and replace pas fluid to verify fault. It could be in the steering rack.
If no improvement, try disconnecting steering rack from hubs and turn by hand to see if you can feel tightness. Check hubs for freeplay whilste undone.
1999 suzuki vitara electrical issue/ after
It isn't typical for the parking lights to be controlled by a relay. These are mostly wired directly from the main lighting switch via a fuse unless it is a multiplexed computer controlled system. If so the Haynes wiring diagram will be needed for deeper investigation.
I suggest you begin by checking the fuses.
Not finding what you are looking for?