Subaru Impreza - Recent Questions, Troubleshooting & Support


The click you hear is probably the blower motor relay . Does your vehicle have A/C ? Drain is probably plugged ,that's why all the water was in there . Do you know what a wiring diagram is ? How to use a voltmeter to test electrical circuits ? Free wiring diagrams here http://www.bbbind.com/free-tsb/ Enter vehicle info. Year , make , model an engine . Under system click on HVAC , then under subsystem HVAC controls will come up - pop in on it's own . Click the search button then the blue link's one at a time . Does your vehicle have manual or automatic climate control ? Second link is automatic ,first link is for manual . https://www.youtube.com/watch?v=3bXZWKUZL9k

Subaru Impreza... | Answered on Jan 22, 2019


Not overly familiar with Subarus, but they're all just nuts and bolts lol.
Pretty much all outside handles must be removed from the inside. Start by pulling the inside door panel off by finding and removing the securing screws and then lifting it in an up and out fashion. The panel is usually held in place by plastic grommits and a few usually will break in this process (it's just how it is) but it's not critical.

Now that you have access you'll most likely have to remove/disconnect the door latch rod and possibly the locking mechanism to reach the outside 'skin' of the door and access to the inside of the handle.

From there it should be pretty straight forward to remove and replace it with a new one. Good luck!

2003 Subaru... | Answered on Jan 17, 2019


IF you go to a major autoparts store they have a testing unit and can tell you if it is the FOB.

Subaru Impreza... | Answered on Jun 17, 2018


see a subaru dealer for assistance .

Subaru Impreza... | Answered on Apr 16, 2018


If it has a timing belt,change it NOW!

1998 Subaru... | Answered on Mar 21, 2018


I think you could use this manual method instead.. My nephew
use it to repair my car and it's totally perfectly fine now. Here's the website he bought it from. www.reliable-store.com

2009 Subaru... | Answered on Mar 07, 2018


I would assume they got blocked and have rotted, thus allowing water into foot wells

Subaru Impreza... | Answered on Mar 06, 2018


Don't waste your money on unnecessary sources and unwanted repairs. Get this manual online under $10-15 and get complete guide on whether to repair or not, service it, and how to repair etc
Best Manuals

2008 Subaru... | Answered on Mar 05, 2018


SUBARU Automatic Transmission Solenoid A Dropping Resistor July 2, 2011. Author: Lewis Werner The SUBARU automatic transmission dropping resistor is connected in parallel with duty solenoid A. Duty solenoid A regulates the Subaru automatic transmission fluid line pressure. Like most of the transmission solenoids, duty solenoid A's duty cycle is varied by the transmission control unit (TCU) to control the line pressure.
The dropping resistor works with duty solenoid A in regulating the automatic transmission fluid line pressure. This resistor keeps a certain amount of current flow through duty solenoid A during the 'OFF' portion of its duty cycle. So in other words, duty solenoid A is never fully 'OFF'.
The dropping resistor is located on the right front shock tower, near the MPI (multi-port injection) fuel system dropping resistor. The photos at the right depict the Subaru automatic transmission dropping resistor.
If this resistor fails open, becomes disconnected, or has its wiring severed, one result might be increased shift shock. The reasoning behind this is that without the resistor in the circuit, the line pressure may be higher, since without the current passing through solenoid A during the 'OFF' portion of its duty cycle, it will tend to close further, and thus not bleed off as much pressure from the automatic transmission fluid pump.
If the resistor fails open or is disconnected, it should cause the ATF temperature lamp to flash 16 times on the next startup, since the TCU would be able to see electrically that the resistor is open.
This resistor was used on the SUBARU 4EAT phase I and 4EAT phase II automatic transmissions. It may also be used on the 5EAT though I have not confirmed it. http://www.scoobyenthusiast.com/subaru-components/subaru-automatic-transmission-solenoid-dropping-resistor

1997 Subaru... | Answered on Mar 04, 2018


Time to have the vehicle towed to your local certified mechanic for diagnosis and repair.

1993 Subaru... | Answered on Feb 28, 2018


The heater core is probably clogged, or the valve that lets radiator fluid flow through the core is not working.

2001 Subaru... | Answered on Feb 06, 2018


I it's possible that you have a intake or head gasket leak that's going into your engine block signs to check for if your car seems to be missing just a little bit one of your cylinders could tell you the area that the head gasket may be leaking or the intake gasket need to check your coolant level every now and then to see if you are losing any coolant out of your Reservoir or your radiator

1999 Subaru... | Answered on Feb 02, 2018


2005 subaru impreza
I suggest you try one of those instant download manuals. My nephew bought one for me when my car broke and we could fix it all by ourselves with the manual costing $10. Try it.

2004 Subaru... | Answered on Jan 25, 2018


At very cheap rates you can go for manuals from this store. Just check
2003 Subaru impreza

2003 Subaru... | Answered on Jan 24, 2018

Not finding what you are looking for?

-1,026 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Subaru Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Jonah Oneal

Level 3 Expert

14065 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Subaru Cars & Trucks

  • Forum

View Most Popular

  • Subaru Cars & Trucks
Loading...