Seat Alhambra - Recent Questions, Troubleshooting & Support

could possibly be a faulty oil pressure switch which is located in the block or the head single wire sometimes an engine will have 2

Its most likely running because of 1 of 2 things. The relay is stuck closed so is powering the fan as soon as the ignition is switched on or The water temp switch that turns it on to prevent overheating is stuck . This is usually on the thermostat housing. Try pulling the plug and see if the fan stops? Check the relay by swapping another(Headlights?) to see if that does it.

Most newer cars have _two_ separate fuse boxes. One in the engine compartment and one inside the car. Some even have a third fuse box located in the rear (inside) the car. I have seen owners manuals that make no mention of the third box.

-Fix it. Good luck mai

-Make sure coolant is full then erase the code. Good Luck Mai

-Check in its manual. Good Luck mai

-Replace new one. Good luck Mai

-There are couple things cause that -Spark plug, spark plug wire. -Fuel injector. -Ignition coil. Good Luck Mai

-Good. Good luck Mai

Checked bulb?

well if your pedal went to the floor. that means you blew the line or you lost the fluid. either way you will need to figure out what is leaking and then replace the part. if you got fluid in the res. then the master could be bad

cigarette lights are held in by the outside case being screwed up from the back. pull the earth wire of the case and undo it

dear . check wheel speed sender all( sensor ).

dear . you should check turbo charger . make sure the engine oil is on level .

dear . you need to replace cable between steering and steering col um . around cable can be fix after you check the turn to right and left should be same .check all fuse . ( this cable cut out and connect to ground now

replace gear lever s.w .

keep radio on for 4 hours . if wrong code inter . keep on until the original code back . or contact dealer

this indicator for water at fuel filter . or make sure brake lights is ok if not replace brake s.w

Camshaft setting tool put in position(rocker cover off) pump locking tool inserted, top dead center mark on flywheel in correct position.if not correct something won't line up

you would be better off going to local car sound dealer and getting a wire conversion kit for that car to suit the stereo then no wires need to be cut and can easily be changed back