Rover Cars & Trucks - Recent Questions, Troubleshooting & Support


You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, co mplete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete

Rover Cars &... | Answered 8 hours ago


you can try out some guide fro m here reliable-store
they also provide live chat feature for instant help and it's very useful

Rover Cars &... | Answered on Mar 12, 2019


Usually a bearing type noise when decelerating would usually mean the small bearing on the differential pinion shaft and a noise when accelerating would be the large bearing on the same pinion shaft in the differential.

Rover Cars &... | Answered on Mar 11, 2019


could be the linkage of the arms broke or possibly the wiper motor died. sometimes the magnets in the motor separate from the housing.

Rover Cars &... | Answered on Mar 05, 2019


for heavy machinery cars etc. luckily there are many websites
that can help you repair
for eg site like reliable-store i s very active in this.. instant help, emails and all that's fantastic

Rover Cars &... | Answered on Feb 14, 2019


About 9 quarts. If concerned, fill to 5 quarts and measure with dip stick. Keep adding until full. Then run the engine and check oil again, fill if needed.

Rover Cars &... | Answered on Feb 11, 2019


I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

Rover 75 Cars &... | Answered on Feb 11, 2019


Fuel sending unit.

Rover Cars &... | Answered on Feb 07, 2019


I got this free Pdf manual from an online store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the all the times I fixed the chipper in these 4 years

Rover Cars &... | Answered on Jan 30, 2019


First you need to find out if the problem is going to be in the electrical system or the fuel system. To do this you will need to take off the air filter and spray a little starting fluid into the carburetor and see if it will start. If it does, then you will need to see if the fuel is getting to the carburetor. If it is not, you might have a bad fuel line or plugged tank switch. If it does not start then pull the spark plug wire off and crank the engine to see if there is spark to the plug. If you have no spark then you must check the electrical system.

Rover Cars &... | Answered on Jan 28, 2019


Have you checked the brake switch on the pedal under the dash? Not experienced with your vehicle, but there has to be something to activate the light when you depress the pedal.

Rover Cars &... | Answered on Jan 25, 2019


Perhaps you could google the instruction book for that model ICE. The manual should have a reset instruction!

Rover Cars &... | Answered on Jan 14, 2019


This is an OBD 2 code, and they are free on line. If someone ran diagnostics and gave you code and no explanation meaning, be careful.
https://www.yourmechanic.com/article/p2135-obd-ii-trouble-code-throttle-pedal-position-sensor-switch-a-b-voltage-correlation-by-blake-griffin
https://www.obd-codes.com/p2135

Rover Cars &... | Answered on Jan 12, 2019


I would suggest the following. Get a good lamp or torch. Put the vehicle safely up on axle stands or a vehicle lift. Take each wheel off, one at a time and trace the sensor wire from the pads. Check it is securely fitted in the pad and plug in point. Then trace the wires back past that point. The wiring further back can get worn over time.

Rover Cars &... | Answered on Jan 07, 2019


Hi, You can go to this link that I have attached and you can get solution of the problem
https://www.reliable-store.com

Rover Cars &... | Answered on Dec 27, 2018


Are you sure you put the correct belt back on? It sounds as though the belt is too tight, or the idler pulley is stuck.
If you have the correct belt, check the idler pulley and make sure it can move freely.

Rover Cars &... | Answered on Dec 23, 2018

Not finding what you are looking for?
Rover Logo

Family Lines

733 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Rover 75
2000 Rover 75

54 Questions

2004 Rover 25 1.4
2004 Rover 25 1.4

-24 Questions

2005 Rover 75 1.8
2005 Rover 75 1.8

22 Questions

2005 Rover 45 1.4
2005 Rover 45 1.4

-12 Questions

2005 Rover 45 1.6
2005 Rover 45 1.6

13 Questions

Top Rover Experts

Jonah Oneal

Level 3 Expert

14053 Answers

Marvin
Marvin

Level 3 Expert

84027 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14633 Answers

Are you a Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...