Well, we both know it is on the throttle body. follow the air filter box to the engine. Where it connects is the throttle body. Do you have drive by wire or cable? f you have cable the sensor is across from where the cables connect. If you have drive by wire, You have to replace the entire throttle body. It is a computer in it self.
how did you know the TPS was bad? did you break anything (vacuum tube, wire connector) during repair? good ground? was it really clean in there when you installed new TPS? i don't know the santa fe, but did you disconnect the battery during this? you may have to reset the OBD system. if you have the OBD tester i think it has this function, or check usere manual, possibly a combination of actions involving ignition, shifter and/or lights.
Thanks for the inquiry. P2135: Throttle/Pedal Position Sensor/Switch "A"/"B" Voltage Correlation P2106: Throttle Actuator Control System - Forced Limited Power I would replace the throttle pedal position sensor Best regards, TF
code system to lean. clean the throttle body especially were the throttle plate sits at idle,use a tooth brush and carb cleaner.dirty throttle bodys cause that code and many others.also cause iratic idle and/or stalling.
×