Proton Satria - Recent Questions, Troubleshooting & Support

Replace inner door lock and door handle.

Check wheel bearings.

Replace battery. Test to car. If not working, need to use scanner

Immobilizer. Fuel supply. Ignition. Scan for error codes.

It is usually integrated into the distributor. You need to to the complete unit( distributor).Set the TDC mark correctly and just pull out the old and install the new.

Hi. Thanks for your question. If you need to learn about new immobiliser the best i will recommend you to visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!

Check all door switches. One of them is not properly closed even when the door is closed. There is one in the front bonnet and maybe one for the rear boot/door. If one is shorted to ground, the alarm will go off.

Check technical manual. If none available consider investing in a Haynes manual. Haynes is the information resource for the DIY enthusiast

Check plug cable, if OK, replace ignition coil.

If it's auto, use Proton brand or any Dextron 3 rated fluid.

Check the fuses.

Get the car scanned for error codes if it's injection model. If it's carb model, service the carb, set the distributor correctly, and check vacuum pipes for aircond control solenoid valve. It could have been connected in reverse.

Will do you no good. Even if you turn it off, you cannot start the car without an original key. You need to get hold of your spare key or get one made to start it. These keys has RFID immobilizer chip that has to programmed on the car to make the on board immobilizer recognize it.

Check immobilizer. It may not recognize that key anymore. Get your spare key and try starting with it.