Peugeot Liberte - Recent Questions, Troubleshooting & Support
Plip battery spent message will
hi this is the battery in your key remote, it is saying it needs to be replaced soon or it will not work so just replace the battery in the fob, be sure to do this in 60 seconds or you will need to re-program the fob, just in case you do not get the battery in, in time, here is how to re-program it as follows
Turn the ignition switch to the ON position using the first key.
Press the LOCK button for 10 seconds.
Remove the key and wait for 10 seconds.
Check the Plip key operation.
Repeat for second Plip key if required.
Turn the ignition OFF
hope this helps please comment and rate thanks
Where is the anti pollution filter located in a peugeot 307 petrol
There is no such thing as an anti pollution filter. All modern cars have complicated pollution control devices on them, and unless you know what you are doing and have the specialised test equipment, there is little that you can do yourself. If there is a light on the dash, then you are going to have to take it to a Peugeot mechanic. They will be able to do a diagnostic test using a laptop and hopefully this will narrow the fault down. They will then be able to give you a cost estimate to repair it. It is unlikely you will be able to fix this yourself.
Hi.
I have a Peugeot 106
A blown fuse maybe ,but reading this i would presume your in the UK ,sorry brexitlandia and i would imagine the most obvious cause is the wet weather there and the horn has corroded up ,check for power to the horn when the knob is held in and then report back .
Need to bypass my peugeot expert immobilizer
you can't, you will have to go to a dealer and have a new set made off the vin number, call first. if they can't then you have replace the lockset and probably take it to a dealer and have the security system reset to the key
Re: peugeot 306 engine not starting after being hit in the front bumper
how hard was your car hit?? is it petrol or diesel? if its petrol the first thing that pops to mind is that, under the bonnet near the back (cant remember what side) you'll see a big red button, press it and try agaijn.. this is a knock sensor for if you ever have a crash... ive set one off just by parking and bumpin the car in front
Haynes manual for a Ford Fiesta 2000 free download
Hi, I have a ford fiesta w reg. When I put the heater on, after about 10 minites it blows the resister and stops the windows and indicaters working. I thought if I could take the blower out and check it. The problem is I dont know how to. Is it possoible you could advice me.
David
My Peugeot 307 will not lock remotely, it tries to
its called lock bounce and you can find out which door is causing the problem by opening each door one at a time and lock it with the door open, when youve done that shut them all and try again as they lock in sequince.
My heater has stopped working
Hi,
There is a blower motor resistor , located in the air duct coming from the blower assy. This will have 4/5 wires attached which determine the speed of the motor blower. This will determine the fan speeds depending on the resistor combinations selected. Sometimes the fastest blower speed will work because it has no resistance and gets full voltage.
You can also check the plug going into the fan assy , the plug may have reecieved a knock from a foot and become loose! A circuit tester will be a great help also . Good Luck
Not finding what you are looking for?