20 Most Recent
2000 Pontiac Grand Prix SE - Page 3 Questions & Answers
I need the firing order diagram for a 2007 Pontiac grand prix with a 3.8 motor
the coil pack you removed them and now firing order was lost
the answer is really just the coil pack
can I assume you know all cylinders numbers,
if not that is 2 questions. plugs to pack wiring both
ahhhh the ,3.8L has 3 twin coil packs.
the packs can not be labeled because all 3 are the same paCK
I WENT ON LINE TO SERVICE MANUAL THIS CAR
AND SEE THIS
1987 Pontiac Fiero GT - Looking to why my check engine comes on and goes off while driving and my oil gauge flutters and engine almost cuts off while stopping?
Hi Jeff Dube, that is called the engine wants to stall, i nearly does
and RPM engine is super low (out of spec)
and slow engine can have too low oil pressure;. 800 rpm is the lowest speed RPM allowed (usa epa laws but no engine told)
that is called misfire.
and no OBD2 scan tool on earth works on any
1987 OBD1 car ever.
so scanning it at home is not possible or crazy expensive.
cause are up to 50s.
folks love to convert Fiero to EV battery only propelled,. I would.
2 engines uses. 2.5L and 2.8L
the cars VIN decoded online tells what engine is there, learn that and tell that for 10x better and more accurate answers.
not told when car ran perfect last?
never by you?
last month, year ,decade??
ever give it a tune up, all filters
new spark plugs, Hv wire set,cap and rotor?
so spark is good> cant burn fuel fully lacking good strong spark.
now FUEL
a car like this, this old can have bad fuel.
or had it and never cured, after.
bad FPR, fuel pressure regulator is common for sure this old
clogged or leaking tips INjectors x4
the ECU controls RPM hot.
if RPM is too low that ECU not the fault
it is other reasons many.
the 2.5L has TB throttle body with
IAC valve on this side that is gummed up.
all are that old. really.
the 2.5L not having 4 manifold injectors
has throttle body injection system
like below.
red circle is IAC< it most not gum up or ECU can not ever control idle speeds. (even with perfect spark and fresh fuel)
Where is the canister purge valve located on:
hunt day 10000000000
endless here.
all this is the service manual to read
i bet the gas cap was loose or bad. fix the easy stuff first?
USA car it is here top of engine
install step 4
How to take off the door panels of a 2008 Pontiac torrent
First unscrew the dish shaped piece under the handle. Lift the handle and gently pull on the dish piece. It has a snap next to the window co trol so be careful. The next piece is to remove the cushion oN the door by lifting up o. The end closest to the open door side. ( this step may be skipped but I found it easier to complete the next step) the trim under the cushion is next, p start pulling Very carefuly on the side closest to the open end of the door. This piece is fragile and will break if you pull to hard. There are four or five snaps on this pics so take your time. Once that has been removed you now have acces to the two bolts holding the handle to the door. Finally, pull on the outside edge of the panel all around there are about 8 to 10 snaps holding the panel on.
Pontiac Grand Prix A/C Clutch
A ground is a ground. You should be able to run yourself a new wire to any grounding point on the engine, trans, or frame/ body.
2001 Pontiac Grand Prix doesn't shut off ignition all the way lights stay on
Lock System Does Not Lock
Step
Action
Yes
No
DEFINITION: The lock system will not allow the key to be turned to the OFF lock position.
1
Did you review the Steering Wheel and Column - Tilt Description and Operation and perform the necessary inspections?
Go to Step 2
Go to Symptoms - Steering Wheel and Column - Tilt
2
Verify that the lock system does not lock.
Does the lock system operate normally?
System OK
NO - Go to Step 3
3
Inspect for a faulty lock cylinder or release button.
Is the lock cylinder or release button damaged?
Go to Step 6
Go to Step 4
4
Inspect the shift linkage adjustment.
Is the shift linkage adjusted incorrectly?
Go to Step 7
Go to Step 5
5
Inspect the ignition switch for damage.
Is the ignition switch damaged?
Go to Step 8
Go to Step 6
6
Replace the lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle .
Did you complete the repair?
Go to Step 10
--
7
Adjust the shift linkage.
Did you complete the repair?
Go to Step 10
--
8
Replace the ignition switch. Refer to Ignition Switch Replacement - On Vehicle .
Did you complete the repair?
Go to Step 10
--
10
Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 3
How to remove/ install rear wheel hub assembly with drum brakes on 2005 Pontiac Grand Am
not old what is bad. just the wheel bearing
the drum backing plate and hub simply unbolt and come off
4 volts/ nuts
1; wheel off
2: drum off (is this a question, dont hammer it. it says)
3: nuts behind backing plate.
4: abs sensor unplugged.
new hub
bank on at Tighten the bolts to 85?N·m (62?lb?ft).
if confused read the service manual all steps covered.
even drum off and wheel off ;.on
2006 Pontiac g6 serpentine belt diagram
OLD ONE FELL OFF AND THE UNDER HOOD STICKER FOR SAME FELL OFF TOO?
YES, YES, THEN IT IS IN THE SERVICE MANUAL
WHICH ENGINE, THE VIN #8 CODE IS ENGINE CODE
THE RPO LIST SHOWS WHAT ENGINE IS THERE.
Gasoline:
2.4 L LE5 I4
3.5 L LX9 V6
3.5 L LZ4 V6
3.6 L LY7 V6
3.9 L LZ9 V6
Gasoline/E85:
2.4 L LE9 I4
3.5 L LZE V6
NO ME ANSWERING ALL 7 TIMES.
Not finding what you are looking for?