20 Most Recent 1996 Toyota Camry LE Questions & Answers

Normally just a plastic clip to remove the cover to the fuse box. No need to remove the whole panel. Fuses have to be easily accessible. https://www.autogenius.info/toyota-camry-1991-1996-fuse-box-diagram/ and also https://www.google.com/search?q=1996+Toyota+Camry+LE+passenger+fuse+box+access ..

only one way and thats to remove the engine and gearbox complete

MAYBE SEPARATE PROBLEMS; CHECK THE TIRE AND THE PRESSURE. IF CORRECT, THE DAMPER MIGHT BE BAD.

Hi Anna: Any problem with the steering end of a vehicle is important, so please make getting it fixed a top priority. If you have the experience to get the car jacked up and on a stand, you may be able to find the source of the problem by turning the wheel. It's possible that there is a problem with the brakes, and the rotor is warped. Unless you have an experienced person to help you with this, I would recommend taking it to a brake shop or similar business to get it repaired.

TAKE YOUR CAR TO A OUTO ELECTRICIAN IF YOU DONT KNOW THE FOLLOWING PROCEDURES,first you need to look under the car by the outo box you will find a switch that turns the light on when you select drive make sure it is working ,if not then replace,if the switch is working then take out the cluster unit(that is the clocks)behind the cluster you will find globe holders,check the one for the d light it is probably just blown,replace the globe and assemble again.

best is to do a engine dianostic

Are all the vacuum hoses tight and ignition checked out ok. There is a circuit broken somewhere. Have you experienced any problems when turning the key and nothing happening.

Usually it is a worn synchronizer inside of the gearbox.

When you disconnect the battery, you have to reset the anti theft system and engine immobilizer. The Toyota Allion is a Toyota Corolla made for the Chinese market.

How do I reset the immobilizer on the 2005 Corolla?

Vehicle History https://www.vehiclehistory.com > questions > how-do-i-... Apr 9, 2020 - To reset the immobilizer on a 2005 toyota corolla you will need to insert the original key and rotate it in the cylinder three times in ... 2 answers · Top answer: When the immobilizer is not working in Your 2005 Toyota Corolla the first thing that You should do is try to reset it. Resetting the system is pretty ...

How do i reset the toyota corolla anti-theft system?

Vehicle History https://www.vehiclehistory.com > questions > how-do-i-... Apr 10, 2020 - Attempt a DIY reset by inserting the key in the ignition and turning to the "on" position, without cranking. Leave the key "on" for 10-15 ... 5 answers · Top answer: The anti-theft system of the Toyota Corolla works to disable the fuel injec ..

no car told year, make or model the books on engines are by that. only wiki said this. OHV eight-valve Displacement: 2.2 L (2,237 cc) Bore and stroke: 91 mm × 86 mm (3.58 in × 3.39 in) This engine was available either carburetted (4Y) or fuel injected (4Y-E, called the GW491Q/LJ491Q and also 4G22B for Chinese manufacture). As fitted to a 1989 Daihatsu Delta truck, the carburetted 4Y produces 70 kW (95 PS; 94 hp) at 4400 rpm (SAE net)[5] and 18.6 kg?m (182 N?m; 135 lbf?ft) at 3000 rpm.[6] Applications 1987.09 - 1995.12 Toyota Crown (YS132, overseas specifications) Toyota Van (Town Ace overseas specification, Tarago in Australia) Hiace third generation (overseas specification) 1979-1988 Toyota Stout (YK110)[citation needed] Daihatsu Delta 1993-1995 Daihatsu Rocky F95 Toyota Industries forklifts Toyota 4Runner (Australia) Volkswagen Taro 1985-1997 Toyota Hilux fourth and fifth generation sorry nobody can guess the car or the country . nor the VIN.

Bottom of the manifold.follow the top radiator hose to the head. Located on driver's side of engine block has a plug with brn and white wire

https://youtu.be/ww0ottmbzes?si=-yS53v24dfOmvU55

Hi Anonymous, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? step 1 remove battery neg lug or BOOM wrap the lug in a shop towel securely not pull the alt if not you blow up a 120+ or more fuse and now the ALT is dead, even 10 new alts are now dead. see? never skip step 1 in the service manual or BOOM fact #2 its not a tiny ATC fuse that blew out. I found it at Mitchell-1 fuse 3 exploded (done wrong) so the harness dies not catch fire. car fires are never fun/.

It is not clear whether your key fob continues to work for the passenger side door. If it does not, you should replace the battery in the fob. Such batteries are available at Wal-Mart among the batteries. If the sliding door on the driver's side makes a noise but fails to open when you use the fob, the latch motor maiy have failed. If the cable in the side door has frayed and snapped, this would explain why you can manually open and close the door but the electronics won't move the door. And if while trying to close it manually, the door fails to latch properly, this is why you get an alarm. If the latch motor, cables, or any other components are malfunctioning, it could lead to the door not closing securely, triggering the alarm. Check your latch mechanism and cables. If you can determine the malfunctioning part and replace it yourself, that is cheaper than going through the dealer. Here is a service manual: https://www.manualslib.com/manual/1061909/Toyota-Sienna-2004.html What To Do When Your Sienna's Side Door Won't Open Or Close ' Toyota Parts Center (olathetoyota.com)

Exactly which nuts and bolts do you need the torque settings for? Not all fasteners on an engine use the same torque setting. For example, a valve cover bolt needs a low torque setting where a cylinder head bolt torque setting will be much much higher. If your rebuilding an engine it is usually a good idea to buy a good quality workshop repair manual which will have all the settings you need.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

sounds like there could be several reasons why your Toyota Gaia with the 1AZ engine is experiencing acceleration issues. It could be related to fuel delivery, ignition, air intake, or even mechanical issues. Have you had a mechanic diagnose the problem yet?

Question edited for clarity. You can't because the door is tucked into the sills by 2" to 6". Look at how the one on the other side looks. You will see. https://www.google.com/search?q=Toyota+ipsum+remove+rear+door+panel ..

Yes, a failing injector pump could be causing the issue of the Toyota Hiace starting intermittently after about five attempts. Addressing the injector pump issue promptly can help avoid further engine problems and ensure reliable starting and performance of your Toyota Hiace.