20 Most Recent 2008 Toyota RAV4 - Page 4 Questions & Answers

lost the operator guide? page 135? it says, there is a malfuction in the system. SRS air bags get it serviced, and no, they can not be turned off. page 137 4wd it states. if the "4WD" warning light remains on...This indicates that the system may not work properly. Contact your Toyota dealer to service your vehicle. you can read the words any time. here at "TOYOTA" http://www.toyota.com/t3Portal/document/om/OM42726U/pdf/01_06.pdf

check relay for the locks and also wiring in the doors there is generally one module that runs the system also check the switch in the door it may be bad

id believe him, get it fixed. you have bad wiring in that feed, or corrosion find it and correct it , or get someone who can. 2 ways. only 2. DIY or take it IN.

Radio head end , aux input . noise its a bad cable. get a new cable yours is bad. you never said what it was, plugged in. the cable must be shielded. if not noise. shield broken , give you noise. there are many magnetic noise sources in the car 1: alternator (sounds like tone) 2: spark. (hash noise, or clicks at idle)

When you replace the batteries in a key fob you usually have to reprogram (kind of a sync) the fob to the car. Each manufacturer is different and usually involves turning the key over a certain number of times ( like 8) then operating the fob in a certain way like holding the lock button down for three or so seconds. I found out how to do mine on YouTube

double posted, back one. it 2.4 L right? not 2.2? d4d 2.2 read the TSB on this engine and recalls>? for head gasket ? best is not to guess. do it right. an use the sequence chart. most HG fail soon after for not doing the 3 tests. warp head, warp deck, and surface conditions. see alldata.com better the FSM and all TSB on head. here is one on site spec. for both motors. 2AZ-FE/D and/or 2AZ-FE/E Step 1: 52 ft. lbs. Step 2: plus 90 degrees my wild guess INSTALL and not removal? unsaid. front is left here, cam cog side left INSTALL SEQUENCE. F 8,6,1,2,9 F10,4,2,5,7 F= front or #1 cylinder end. take down is different order. (its aluminum, nothing trivial)

clean the throttle body out with carb or throttle body cleaner. My 2004 Volvo S60 was stalling at stops and cleaning it fixed the problem, the carbon build up doesnt allow it to function properly

check if the battery needs to be replaced