20 Most Recent 2006 Toyota Corolla Questions & Answers


There is a problem with the door switch the door is not pushing the switch in completely. Here is what you do close all the doors, then you open them one at a time with all the other still closed. start with the drivers door. open and look for the pin with that the door touches when you close its on the bottom close to the back of the driver's seat it has a black rubber covering it. Press with your thumb in and see if light goes out. Check all other doors in the same way you will see which door switch is not being pressed in completely when door closes. If you find it a quick fix is to pad the area on the door that makes contact with the switch to push it in, for example you can use one of those round sticky cushions that you use on the metal chair legs to prevent them from scratching your wood floor. However if you can solve the problem in this way you may have to take it to electrical mechanic or I will be able to provide more help. contact me and leave me a feedback. Good LUCK

2006 Toyota... | Answered on Apr 23, 2019


At
www.reliable-store.com
get complete guide on whether to repair or not, service it, and how to repair etc, along with wiring diagrams, electrical diagrams, torque specs, error codes, everything.

2006 Toyota... | Answered on Mar 13, 2018


Check all the fuses located in the lower panel of the dash board on the passenger side with a test light 12V or multimeter. Ground one end of the tester to good known ground and the tip to each side of every fuse one by one. If the tester light glows that particular fuse under test is OK. If not, that fuse is burnt. Replace it with the same rating of new fuse and you are good to go.

2006 Toyota... | Answered on Feb 09, 2018


Sure I will tell you how to get away from those annoying beeps I know what you're talking about it's very easy what you want to do is get on YouTube and type in Toyota Camry how to disable the beeps on my keyless entry and once you do that you can just press it and your doors will lock without the annoying beat you can also check with the dealer and they will teach you for free how to do that I hope my answer has helped

2006 Toyota... | Answered on Feb 06, 2018


are you getting a battery sign in your dash if so it is usually the alternator not charging the battery check battery alternator and belts good luck

2006 Toyota... | Answered on Jan 30, 2018


get a test light and check your fuses also check for rusty ground wires

2006 Toyota... | Answered on Jan 30, 2018


Does it run for a full minute or start then shut off within a few seconds?
If the latter, then it sounds like the anti-theft system has kicked in and needs to be reset.

2006 Toyota... | Answered on Jan 22, 2018


Sounds like possible Idle Speed Control (ISC) issue. Start by having computer codes read by dealer or other facility.

2006 Toyota... | Answered on Jan 09, 2018


Open hood ensure new battery is disconnected.
Open main fuse panel cover under hood and remove horn relay (so you don't have to listen to the horn).
Use the key to lock the drivers door.
Connect the positive battery terminal.
Connect the negative battery terminal (security system will now activate, hazards lights will flash and horn would be going off if the relay was not removed).
Use the key to unlock the drivers door.
Get in, close drivers door.
Use the key to start the engine.
Security system will deactivate.
Get out of vehicle, reinstall horn relay, replace fuse panel cover, close hood.

2006 Toyota... | Answered on Jan 05, 2018


There probably is an I/P dimmer already there.

2006 Toyota... | Answered on Dec 21, 2017


check the cable adjustment for codes p 0121 before spending money on position sensors
the pressure (TFP) will fix the transmission problem
P0607 is the control module
however before getting a replacement ECM check for wires and connections
check for moisture and/or dirty pins in the connections
I would go for good replacement parts from a wreckers/junk yard rather than new parts to save money or have an accredited service shop check the components first

2006 Toyota... | Answered on Oct 18, 2017


Sometime you can go to the dealer were the car was brought and they might have a spear ??, or you can go and get one programmed to your car. Good luck. Hope this help. Any Toyota dear can help!

2006 Toyota... | Answered on Sep 27, 2017


You have fuel leakage on the pressurized/engine side of the fuel delivery line or filter at engine has a bad o-ring from being over tightened. Check all with engine running. And you should see a bit of fuel on the ground at the leak point.

2006 Toyota... | Answered on Aug 14, 2017


Automatic idle control module and the valve it controls on the engine need attention. Sometimes a simple cleaning of the valve is all that's needed.

2006 Toyota... | Answered on Jun 27, 2017

Not finding what you are looking for?

1,140 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Toyota Corolla
1998 Toyota Corolla

1,211 Questions

2003 Toyota Corolla
2003 Toyota Corolla

1,220 Questions

2005 Toyota Corolla
2005 Toyota Corolla

1,213 Questions

1994 Toyota Corolla
1994 Toyota Corolla

799 Questions

1996 Toyota Corolla
1996 Toyota Corolla

753 Questions

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85108 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Corolla Toyota

  • Corolla Toyota

Most Popular Question

need advice after installing 3zz engine

  • Cars & Trucks
Loading...