20 Most Recent 2004 Toyota Prius - Page 4 Questions & Answers

If automatic tran. your going to have to do a pan drop and filter change! If its a manual trans there should be a drain plug and a check plug ! unscrew drain plug and replace when fluids draining then fill threw check plug intil it starts to drip out hole then screw back on plug !!! autom . your going to have to take out all pan bolts( will start draining when few are loosened ) remove two allen bolts on old filter replace put new pan gasket on and screw back on evenly without pushing gasket out by overtightening them !!

Thanks for choosing FixYa and welcome. If it was the fuse, the entire radio wouldn't work. You either have a bad volume switch or there is no power to the switch. Check the wiring for the volume switch. Perhaps, test the wires with a schematic if you don't know which one it is. If it has power, the issue is inside the radio.

It will be the same procedure as most other new cars. A 2004 Toyota Prius requires the replacement of the wheel hub assembly.

system needs to be reset.....disconnect the negative battery terminal for a minuite, then reconnect

You need to know how to reset the light, a dealer can provide this for you.

was the car in an accident if yes you need to replace or repair airbag unit if no check the connections for driver knee airbag watch free videos on vehix411 com for reset instructions

http://priuschat.com/forums/gen-ii-prius-care-maintenance-troubleshooting/78276-07-prius-wont-start-after-repairs.html

Service plug failure

P1121: Accelerator Pedal Position Sensor Range/Performance Problem.
P1116: Coolant Temperature Sensor Circuit Stack for Coolant Heat Storage Error
P3193: low or no fuel

Removal & Installation

1. Remove the engine under cover.
   
2. Loosen the clamp, then disconnect the air cleaner inlet from the air cleaner case.
   
3. Referring to the illustration, loosen nut A, then turn adjust bolt B to relieve the V-ribbed belt tension.
   
4. Remove the belt.
   

V-belt removal

To install:

1. Install the V-ribbed belt to each pulley.
   
2. Turn adjust bolt B to adjust the V-ribbed belt tension.
   
3. Tighten nut A to 40 Nm (30 ft. lbs).
   

I believe 70,000 miles

replace the bulb, you can access the bulb when you open the hatch. there is a cover at the back of the tail lights. or go to your local autozone or pepboys. they will replace it for you with no extra charge

Hi David,
Which is in Japanese? The hands free device or the radio you are trying to configure your mobile phone too.
Let me know and I can give you more information on it.
Thanks
Jason