20 Most Recent
2001 Toyota Tundra - Page 3 Questions & Answers
Where is the shut-off switch for tundra alarm
Hi, I am not sure where the switch is but 3 months ago the following was posted by:-
liverhuyen2003 answered 3 months ago
Make sure the drivers front(left front) door is closed and you have your car keys. Insert your door key into the drivers door and turn it to the locked position two times. Then turn the key to the unlock position twice. The alarm should be disarmed, now. SECOND TECHNIQUE: If not then take the ignition key and turn the ignition switch all the way ON then OFF then ON a second time and OFF again. These are the procedures for nearly all factory alarm systems. If neither of these works you probably have an after market(add-on) alarm system. Warnings This technique is only for use on your own car that you own and have keys for. If you don't have the keys- disconnect the negative battery cable to stop the horn until you get your keys. Then reconnect the negative terminal and proceed to step one.
Hope this helps!
2001 tundra v6 auto 2wd. the gauages, turn signal, ac, and radio all quit working all of a sudden. have checked all the fuses (both hot and grounds) and all are good
All those things have in common is the ignition switch, that only in accessory, or on (run), or start, allows power to that portion of the fuse block protecting those circuits, everyone you mentioned that quit.
Use a test light or voltmeter, pick a fuse -gauges. With key on, the fuse should show power on it, and across it if the fuse is good. If it doesn't have voltage to it, trace it back to how the ignition switch turns that portion of the fuse panel on (possibly a relay-ignition or accessory relay...I'm guessing), and further, whether any relay involved has a "hot at all time" supply of battery power as the power feed for that portion of the fuse block. This relay's power source would be from a maxi fuse or a fusible link, if equipped, all under the hood.
If the fuse block for all those is powered up with key on, then it may be a common ground problem-somewhere behind the dash.
Stop light does not work
check for other bad light bulbs , a bad fuse , a cut filament on the left light bulb , rusted or lose connection .
Brake lights
ask a real question?
like what are they?
how do they work?
why are mine both dead.?
or ??? questions are like that... ask one.
Left stop light does not work. Replaced light. Fuses ok
the stop lamps are simple
a fuse , a switch, wires, and lamps
if you step on the brake and the voltage at the lamps is not 12v.
then the switch is bad, if there is 12v on one side and not 12v on the output side of the stop switch.
its very simple , flashlight simple wiring,
Not finding what you are looking for?