20 Most Recent 2000 Toyota Camry Solara - Page 7 Questions & Answers

Most likely a loose sensor on the drivetrain more specifically the traction control system easiest to just have it scanned for codes buy a good repair manual like. Haynes or chilton and replace or repairing indicated part from the trouble code

Hi I'm litoshop if the security light stop blinking.then you deactived the alarm if your car has a factory alarm then the same light you see blinking look at it close and see if it's a switch push it in and put the key on and just turn on the dash light then turn it off the it should start blinking agian if it's not the light the look for a small red push botton and do the same as instructed above good luck. if this information has been useful please let us know thank you...

Hello! 7.3 Quarts...Guru..Saailer I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Why was the battery replaced? Theres no reason the the 100 amp fuse to blow unless the alternator is shorted or you hooked up the battery backwards. I think the 100 amp fuse goes to the alternator. If it was hooked up backwards then you may have engine computer damage.

There are literally HUNDREDS of reasons why an engine can stall and not start back up. The place to begin to find the solution for your problem would be to scan your onboard computer system for fault codes. This will most likely lead you directly to the answer.

it could be a few things, you will need to test/ inspect them to be sure. the first thing you want to look at is the fuse. These are generally located in the dash on the drivers side, on the part facing the door. then next thing to inspect.replace is the relay, this is usually found under the dash on the drivers side, along the kick panel. Finally you will want to inspect the switches (both hazard and turn signal multi-switch) for continuity and operation.

there is some big square fuses in the fuse block under the hood and i would say that one or more of these are blown and if you find that one of these are blown and will not pull out some are bolted in on the side of the fuse block and some of the smaller fuses could also be blown but you need to fix the bigger problem first.look closely at the bigger 40-100 amp fuses first........if i can help any futher let me know.............i hope this was helpful good luck let me know...............

There should be a button on the gear selector. Push it and the light should go off. All it does is turn overdrive, or 5th gear off.

you need to use your key fob to reset the anti theft system you should be able to find the procedure in your owners manual under battery replacement.

move the steering wheel right and left while you turn the ignition on

The only way it could affect your engine is if it becomes plugged, not allowing exhaust gases to pass through it on the way to the tailpipe. It merely gets hot enough (600 degrees) to burn any unburned hydrocarbons, if it is failing it is not getting hot enough to 'light off' to do it's job, or it is getting too hot (glowing red?)-this means your engine is misfiring badly and you need to fix it before it becomes catastrophic.

Take it to the dealer for a general inspection, pay for it, then according to the results decide. if the car has lot of corrosion and the problems are related to bad connections due to corrosion also mechanical parts damage by rust then is time for another car Sorry amigo. If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92