Car will start but will not shift into gear. Shifter seems to be locked in place it is my suns car and I'm getting this info from him he's had it for a while and knows what to do. foot on break ect.
it may be a brake light switch. on most vehicle the brake light switch releases the shift lock that may be your problem
Posted on Sep 09, 2008
washer does not work
there no fuse for just the washer it has the wiper on that fuses if you press the washer and wiper start its not the fuse it a bad washer pump pierre
Posted on Oct 04, 2008
do I refill my car with 4 or 4 and a half quarts?
It is 4.1 quarts.
Put 4 qts in, after changing the filter, and start it.
Run it for 30 seconds, shut it off, check the dipstick and add until the oil is at the full mark.
Hope this helps, and Thanks for choosing FixYa!
Posted on Oct 25, 2008
The driver side seatbelt on my 2005 Corolla won't retract. Is there a way that I can rectify it myself without having to bring it to the dealer?
1)move the plastic cover over the seat belt out of the way to gain access to the two mounting bolts for the seat belt mechanism. Use a 10mm wrench and a 14mm wrench and remove the two bolts holding the seat belt mechanism to the body. Use a small drill bit or small screwdriver and make one hole in the plastic cover on each side of the seat belt mechanism (the covers say "do not remove plastic cover". Spray lots of wd40 in each hole. Then exercise the seat belt. When the mechanism allows the belt to be retracted, retract the belt all the way out and exercise the seat belt. Reinstall mechanism with both mounting screws in original position and put plastic cover back in place. Good luck. New seat belt costs $100.00 from dealer and are hard to find working in junk yards. I have fixed several of them this way.
Posted on Jan 21, 2009
wheel bearing replacement left front wheel Hello Everyone, I may need to replace the wheel bearing on my right front wheel of my Corolla wagon. How can I know for sure? And how can I find out how to do it? Wheel bearing replacement is not even mentioned in my Toyota Corolla 1996 Haynes Repair Manual.
Diagnosing the bearings can be tricky depending on severity of wear. Typically - drone noise at highway speeds, squeeling, clicking or grinding noises at low speeds that reduce during braking, or pull off the wheel and brake assembly and check the bearing for slack or smoothness of rotation by hand. While doing this, check the brake assembly thoroughly - generally a more likely culprit of wheel noise.
Wheel bearing replacement is not for the novice backyard mech. - you will need pullers, press, etc. If you can get a rebuilt assembly - much easier.
Posted on May 08, 2009
remove rear motor mount
Rear motor mount removal is part of procedure for removing steering rack. Refer to repair manual. It requires dropping the engine crossmember. The front pipe support also needs to come off. See the image below.
Frank
Frank's Friendly Cars Maui Car Rental
www.MauiCarRental.biz
Posted on Aug 01, 2009
where is the knock sensor on a 96 corolla?
the knock sensor is located at the center of the engine in the rear, heres a diagram witha list of the sensor locations,it shows the knock sensor, it looks like its in the front of engine but its not its in the rear, good luck.
Posted on Feb 23, 2010
looking for fuse to disable toyota corolla alarm,please help!!
Remove fuse labelled "dome" on engine compartment fuse box. unfortunately this also isolates the radio. I have found when re connecting battery alarm goes off. remove "dome" fuse and then replace it. all ok then.
Posted on Dec 07, 2011
car wont start because it is in security mode and i have lost the remote
2nd-ing the 'unlock door with key' trick
Posted on Apr 12, 2015
when I turn the key ,it does not even go click. Battery is new, is there a fuse that controls this ? and where is it located ? All help gratefully received
There is a starter relay inside the cabin. Fuse box is located on left panel down in driver's footwell . If it is still the original one it will be a light blue square fuse located at the very top of the panel and it will say starter relay.
Posted on Feb 15, 2013
1,106 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
792 Questions