20 Most Recent 1989 Toyota Land Cruiser Questions & Answers

the oil pressure switch is on pssenger side, lower engine area,beside oil filter, mounted in engine block. The pressure relief valve is in the oil pump, in which case, you have to drop the oil pan,and take off the oil pump.

Check to ensure fuel pump fuse hasn't burned out. Try spraying starting fluid directly into the throttle body to see if it tries to catch.

power steering box --- atf oil manual---heavy grade gear oil (80-90 oep) or if the seal is leaking --grease

fj 60 series 2f and 3f petrol en gines always ,going back to the first of these motors have alway s been a problem to start particularly hot ,over several days fuel can drain back from the fuel pump.BUT I am a liile confused,you say,FJ 62, THAT IS APETROL ENGINE WITH A CARBURETTER. yet you speak of injectors,if it is a DIESELmotor the vehicle is HJ60 with a 2h motor ,if it is a HJ62 then it will have a 12HT TURBO diesel motor,I can tell you where to look to solve the problem no problem at all, but i need an accurate description of the vehicle as they are all different engines

The bushings inside the shackle (where the bolts go through) are worn out.

Land Cruiser Head Bolt Torque Sequence

https://www.sor.com/cathead.sor

It should be if a six cylinder, 153624

same note

see notes

http://autorepair.about.com/library/firing_orders/bl-to, I needed motor size ,but also found 6cyl gas model =1, 5 ,3 ,6 ,2 ,4 firing order

Fit a new water pump ,the seal is leaking and stops when it warms up.

try tapping the pisto with a punch to realign it then use a small magnet to remove it