20 Most Recent 1988 Toyota 4Runner Questions & Answers

check the wires at the battery, probably they are not making good connections, or replace the battery terminals. be sure to clean up wires an terminals,,, and check for battery negative.cable are clean and tight at the engine

Hello there. Where is this vacuum pump located in the engine compartment that's leaking? I'm attaching a pic that may help you.

Hello, open the fuse box and look for a large 80A fuse, replace it if necessary, if it doesn't have the fuse some early versions used fusible link wire from the positive battery terminal instead, this is a fuse and will burn out inside the insulation if there is a short, check it using a 12 volt test light, you can get fusible wire from the auto parts store.

it is in the fuse pannel inside the car

the sensor is wats wrong there

if it was me I would take the alternator off take it somewhere and have it tested because it sounds like it has a bad voltage regulator in it

hi there you may need to check the fuel pump relay. good luck.

hi there. oil might be a bit to thick to penetrate past the piston rings. i should try using something like WD40. or similar. good luck.

no. not normally, unless the bushings the shaft rides on are completely shot. remove the sensor and wiggle the shaft.... feels tight then its good

What was the reason for replacing the TPS in the first place?

Replace the spark-plug wires.

there is acctually 3 different fuse panels. theres one right inside the driver side door. theres one behind the glove box and one under the hood

a BMW toyota, this an engine swap question? if car is stock, above is no proof then alldata.com is your , best bet. fast and easy.

You should take the starter to the parts store and have it tested, if their is a problem with the starter itself they can tell you and what is wrong.........hope this helps.