20 Most Recent 1987 Toyota Xtracab Questions & Answers

0helpful
1answer

I have a 1987 Toyota Xtra Cab 4x4 that keeps

The bottom fan belt on my 87 xtracab recently broke in the middle of traffic and those same warning lights came on immediately, so you might want to have the belts checked, especially the one driving the alternator.
4/27/2011 7:30:33 PM • 1987 Toyota... • Answered on Apr 27, 2011
0helpful
1answer

Location of fuel filter 87 toyota van

1987 Toyota Truck Van 4WD 2.2L FI 4cyl
The Fuel Filter is located front seating area, center, under engine cover, passenger side of engine compartment, near firewall, mounted in fuel line.

Hope helps with this (rated this) Good luck.
1/11/2010 10:32:18 PM • 1987 Toyota... • Answered on Jan 11, 2010
0helpful
1answer

Where is the fuel filter located?

Under vehicle, passenger side, below seating area, near fuel tank, mounted on frame rail in fuel line
5/24/2009 4:19:37 AM • 1987 Toyota... • Answered on May 24, 2009
0helpful
2answers

Turn signals and wipers don't work but high beams and curise cont

check your charging system the voltage at the battery should be 12.85 Volts WITHOUT the engine running and 13.2-14.5 Volts with the engine RUNNING. If the voltage is low it probably means the alternator is at fault.
1/29/2009 12:14:16 AM • 1987 Toyota... • Answered on Jan 29, 2009
0answers
0helpful
1answer

1987 Toyota Pickup 4x4 Problems I

hello, it sounds like the alternator is the problem, most auto parts stores can check the alternator/charging system at no charge without removing it from the truck, I'm sure you will find that the alternator needs to be replaced.
4/2/2017 7:36:48 PM • Toyota Xtracab... • Answered on Apr 02, 2017
0helpful
1answer

I have a 1992 Toyota truck 3.0 v6. When

is it petrol? if yes change ht leads and coil pack. misfire should clear.
4/1/2017 4:13:01 PM • Toyota Xtracab... • Answered on Apr 01, 2017
0helpful
1answer

Left hand headlight not working on dip

replace the globe as it may be burnt out.
1/26/2014 9:26:18 AM • Toyota Xtracab... • Answered on Jan 26, 2014
0helpful
1answer
0helpful
2answers

How to bleed the air

You have to take the filter of and then fill it up with fuel then replace filter without spilling any fuel out to cause more air to get in the line. When you try to crank the car or truck over it may take a few trys but it should start after a few trys.
5/7/2012 1:15:31 AM • Toyota Xtracab... • Answered on May 07, 2012
0helpful
1answer

My truck wont crank

Pretty vague statement. Need more specifics.
8/23/2011 7:43:38 PM • Toyota Xtracab... • Answered on Aug 23, 2011
0helpful
1answer

How do you remove front

We don't live in the 1960's any more

Most vehicles have wheel bearing hub assy's

You remove ,in most cases 4 bolts from the back or
inside,that hold it onto the steering knuckle

First you remove the axle nut
8/1/2011 7:04:06 PM • Toyota Xtracab... • Answered on Aug 01, 2011
0helpful
1answer

I have a 2008 Toyota

First of all, have the valves adjusted. Second, if that does not fix it, try a slightly higher-viscosity oil, and then have a mechanic run an OBD-II scan on it. But definitely have the valves adjusted first.
7/21/2011 8:59:16 PM • Toyota Xtracab... • Answered on Jul 21, 2011
Not finding what you are looking for?
Cars & Trucks Logo

12 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Xtracab Toyota

  • Xtracab Toyota

Most Popular Question

fuel filter located

  • Cars & Trucks
Loading...