20 Most Recent
1987 Toyota 4Runner Questions & Answers
Tricks to pass emission test
move to Florida they don't do them state inspections there unless requested
but really most things you can do can mess up your car ,
all cleaners do other weird side effects .
How clutch replacement
disconnect battery, remove starte motor, remove drive shafts, support and remove cross member,remove clutch slave cylinder, remove bellhousing bolts and while suspending transmission remove and lower transmission.//remove preasure plate and clutch. Good idea to replace spigot bearing and throw out bearing while you do job. allow 4-5 hrs for r&r. Refit in reverse order.
Gas mixture
I don't know what year you are working with, but I have an 87 that was doing the same thing. I converted the air filter to a K&N system and did away with the old filter box. The problem did not go away. I talked to a Toyota specialist and he told me in the top of the mass flow sensor there is a plug that you need to drill out. There is an adjustment screw that regulates the air mixture with the gas. It is located on top of the mass air flow sensor that connects to your air filter box.
Rear power window stop working also lost my power
There are two things that can cause this either there is a fuse that blew that connects both the window and the radio or its two seperate issues fuse to stereo and the window regulator went bad or switch on the window. First thing I would do is check the fuses if you confirm the fuses are all good you will want to diagnose the wiring on the stereo and ensure there is a good power and ground. If the window has 2 switches make sure its not locked if thats a option then go ahead and ensure it doesnt work on either switch if not you will want to get the door panel off and check for power and ground at the regulator if there is most likely the regulator went out and will need to be replaced. You can get the window up use a board to allow it to stay closed until you get a new regulator. Please let me know if there is anything else I can do for you. Thanks for using fixya!
James
I replaced the head gasket and now it won't go
This is a weird one. You shouldn't have been anywhere near the ******. How about the clutch fluid reservoir and cylinder? Maybe it got knocked around, or somehow drained to where it can't disengage properly. Can't think of anything else, unless it's an automatic, then it's probably a vacuum hose you forgot to hook up.Let us know what you figure out.
Not finding what you are looking for?