1986 Toyota MR2 - Answered Questions & Fixed issues
Who best services/overhauls a 1984 Volvo 240
It depends on what you need overhauled and what is wrong with it. Check on Swedespeed or turbobricks, or any of the Volvo lists - there may be a Volvo guru near your location who is trusted and has decent prices.
In Colorado, there's Carl Duke Volvo in Loveland and in Denver you have Voltek - both are excellent independent shops with people who love Volvos and know them inside and out. And not just the new stuff.
9/18/2013 6:01:49 AM •
1986 Toyota MR2
•
Answered
on Sep 18, 2013
•
117 views
Where is the fuel pump?
The pump is in the fuel tank. To test short pin 1+2 on the air flow meter connector. Turn the ignition key to run position (2 click) and listen for the whir or hum of the pump.
6/12/2014 1:39:18 AM •
1986 Toyota MR2
•
Answered
on Jun 12, 2014
•
180 views
How to remove from a 1986 Toyota MR2, the Intermediate Steering Shaft?
If the U-joint is worn out on part # 45260, then that whole part needs to be replaced. There are no serviceable items on that piece.
In order to remove it, you'll need to remove the retaining bolts part# 90119-08560 (top and bottom of said shaft), then you may have to pry the collars apart to get them to release from the other piece of the shaft.
To make it easier, disconnect the lower portion of the steering shaft from the gearbox/rack and pinion. Also note, the shafts may be D shaped so shaft components may only be installed one way. If they're not, you'll need to mark positions on the remaining shaft components to when you're installing the new part the orientation stays correct.
It also may be beneficial to lock the steering wheel in a set position so it doesn't rotate otherwise your turn signal cams may be in the wrong orientation and may not work properly. i.e. may not lock when depressed, or turn off at the wrong steering wheel position.
5/16/2014 3:48:56 PM •
1986 Toyota MR2
•
Answered
on May 16, 2014
•
248 views
Doesn t start
COULD BE A BAD CONECTION @ BATTERY ,OR STARTER COULD BE GOING OUT,
10/16/2013 2:51:25 PM •
1986 Toyota MR2
•
Answered
on Oct 16, 2013
•
73 views
My mr2 86 doesn't crank
Make sure you have a good battery/connections. Make sure you have power down to the starter on the B+ terminal if not replace faulty wire or clean/dirty connectionson ensure connections are tight. While someone turns the key make sure you have power in the S terminal. If power make sure the engine isn't locked up and replace the starter. If no power you may have an issue with the ignition switch circuit (stitch, wiring, fuses....)
3/9/2012 11:29:16 AM •
1986 Toyota MR2
•
Answered
on Mar 09, 2012
•
312 views
1986 toyota mr 2, im
if you mean the ecu, i think its in the boot on the wall shared with the engine bay, just remove the liner & it should be there.
11/17/2011 10:47:48 PM •
1986 Toyota MR2
•
Answered
on Nov 17, 2011
•
81 views
Not finding what you are looking for?