20 Most Recent 2007 Toyota Tacoma - Page 9 Questions & Answers

The universal joint or U-joint. These are used to change the direction of force. They can be check by trying to move the driveshaft to see if there is any play in the joint. A common symptom is a thumping or clunking sound (often right after coming to a stop). They help keep the driveshaft turning in a balanced fashion. Hope this helped and best wishes.

this could be the result of sticking/hanging caliper(s) which hold pressure and reel the lining off pads in a quick fashion.check calipers

you cant i dont think..you need to go see the toyota dealers and they will do it in 5 minutes...hope i helped you :)

try removing the remote fob battery for 10 secs then replacing, i get this problem a lot if the fob battery is low.

you need to open the dash ....remove the panel that the lighter is in .....and replace ....you should get the same one from a junk yard to fit you truck exactly

Probably one or more (fuse(s) ) under hood in power distribution box.

its in your fuse panel with your other fuses on your drivers side on the side of the dash board there should be a panel that you take off it'll have your fuses in it with a description of what each fuse is for.

ASE Mechanic:
An ! light means you have a light out some where on the vehicle. and never trust firestone, they are out for commission and not customer satisfaction or have no idea what they are doin.

the noise is from a worn out clutch pressure plate release bearing, replace it..

Only a guess but it would seem that is your check engine light... drop by an autozone and have the scan the codes (free) and let us know what they were ... or they will tell you what they mean sometimes.

Robert

If your new rims do not have the transmitters installed, the light is not going to go out.

If the new rims do have the transmitters installed, and one is broken during the installation, the light will not go out. It is common for tire machines to damage the transmitters.

If the rims have the transmitters installed, and all the tires are at the proper inflation, I would check the spare tire pressure. It too is monitored.

Thnaks for choosing FixYa for assistance. Please feel free to comment back if you have any futher questions. Thanks.

If your vehicle has the silver-metal valve cores (as opposed to black rebber), the tire pressure light goes out once the tires are at or above the minimum inflation pressure. Note that the SPARE is also checked for proper inflation by the system. What I would do is check the spare for proper inflation. If it is low, resetting it should cure your problem. If the light does NOT go out, the dealer who put the tires on may have damaged your tire pressure sensor. To check that, you need a Toyota technician to check the output of your 5 sensors with their tire pressure sensor diagnostic tool. If one is not reading, I would take the vehicle back to the tire guy & make him buy you a new one, They are not cheap.
Hope this helps.

My wifes Pontiac Grand Prix does the same thing. It is a preset thing. Every x amount of miles it comes on. On her car there is a menu under the screen that you go into to reset it. This is not for sure but every time hers comes on the psi is right. I am not a mechanic so you might also look for other causes aswell.

more than like have a broken axle shaft, un hook the rear drive shaft and put it in 4wd if it wont move then you know you got a broken axle shaft or spider gears broke in the pumpkin

Hi and welcome to FixYa,

Initially, would suggest to do visual inspection of the sensors and the connectors on each wheel. Since doing so would require lifting the vehicle, it might be to your advantage to seek the services of your dealer or qualified professional. Alternately, the vehicle could of course be jacked one wheel at a time, but inspection would be cursory at best. This also poses a potential risk to whoever is going to inspect.

Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.

Its behind the glove box you will see a cover with tabs pop it off and you will see the filter