20 Most Recent 2007 Toyota Tacoma - Page 6 Questions & Answers

Check the right wheel bearing, brake pads, rotor, and claper they might be touching some thing.

You are correct the IAT sensor is built into the MAF unit, and uses wires 4 and 5.Wire 4 is Red with a Blue stripe.
Wire 5 is Brown.-----
To see its diagram, click the link below:--- http://technoanswers.blogspot.com/2011/07/which-two-are-iat-wires-on-2007-toyota.html ---------- This will help.Thanks.Helpmech.

rear wheel bearing or dirt between brake pads or rubbing wheel.

Hi, What is problem?

I had mine changed, I spilled Iced Tea in my console. It is burried way down inside the console. The dealer had a hard time replacing mine, they kept it an extra day

Flashing means that it did not engauge, you may have to put it in 4 LO and let the truck roll a little to get it to engauge, same with the locking rear diff. These lock via electric motor and you may need to move to get it to mesh.

ONLY A LOOSE WIRE UNDER THE DASH. SOUNDS LIKE A LIVE WIRE

The heater and AC use the same fan to blow air.If the heater works I would check for a blown fuse for AC look in owners manual for location

Hello and welcome to FixYa!

If the battery light is on, I strongly suggest that you have the battery charged. It can be an indication of a weak battery or a faulty alternator. If the battery light still on after charging then the problem will surely be on the alternator itself. If that's the case the alternator should be replaced to resolve the problem.

If the battery won't hold charge even on a new alternator then the problem will be on the battery itself. It surely is in the end of it's service life and replacement will be necessary.

You may try to reset it to by removing the positive battery connector, letting it sit for at least 5mins. then reconnect it again. This will reset the system and can get the battery light off.

Hope this helps and thank you for using FixYa! Have a good one!

http://www.toyotanation.com/forum/showthread.php?t=193630&highlight=transmission+dipstick+location+2007+toyota+tacoma+4x4

This link will help you for sure!

Hi Bob,

That is a really common issue with the tacoma overhead console. Components on the board oxidize and the unit fails. We fix these on a routine basis, have a warranty, and removal instructions; check it out www.autoclockrepair.com. Please let me know if I can help, thanks!

With an OBII scanner (fault scanner/reset tool) you can buy one for about $60 or any good parts store can reset it for you FREE (Autozone, Advance, etc..)

generally that is an indicator of a warped disc, odd on a car that new. if is is still under a 5 year bumper to bumper, and the mileage has not been exceeded, then a dealer will most likely give and install you some new discs. go ahead and pay for a new set of pads as well as they will not be covered under warranty, and the additional labor will be zero. I would definitely take this to a dealer in case there is some type of recall on a caliper or something, toyota brakes should be good much longer before a service. if you have a bazillion miles on it though you will be paying the whole bill.