Top 20 2007 Toyota Corolla - Page 5 Questions & Answers

1. Ignition system 2. Spark plugs 3. Fuel pump control circuit 4. Injectors 5. Idle speed control valve.

Keyless entry remotes allow you to put down and roll up the windows in your car. You would have to have the power windows feature installed on your keyless remote. --------------------------------------------------------------------------------------VVDI VAG Vehicle Diagnostic

Slow down everything has limit.

The radio may have a short blowing the fuse. The power steering ECU could also be the culprit since it's electronic on a Toyota.

Check for bad earth connection at light .or a broken wire connector

yes over time it will kill the battery check the door switch some head light switches have a position that keeps the interriier lights on

Failed Oxygen Sensoror several other reasons thecode came upGoogle the code & read upon all the reasons you have a faultin that systems

Unless the car is sold in the USA or other english language country there is no manual.

Pastor Norman, Pastor Dave here.Since you already replaced the left rear brake light bulb and that didn't help, please take that bulb socket out again as you did before, and find a way to test the bulb contact for electricity when the brake lights are on. You should get 12 volts out of the "hot" metal contact. If the other two lights are on, and you have no current in the socket, you either have a bad socket, or a broken wire somewhere. One way is to go back a few inches and skin off the insulation of the brake light wire and see if there is current back a few inches from the socket. Cover with tape when you finish.If you decide to cobble a solution, you could run a good wire from the other brake light that works and splice it in to the dead wire.Be Blessed.

Automatic--it has to come out & be rebuiltStandard transaxle--may have to come out &apart to replace the sychro rings or other internal issuesCheck linkage first

Remove the plastic triangular trim piece behing the mirror on the inside, it just pops off, you will three 10mm nuts, remove them and pull the mirror off, you'll have to disconnect the electrical connector if it's a powered mirror.

Easy, jus replace the bulb. No more than $20 and it should b an easy on n off wit little to no tools. But first have someone look at the lights or u and with the key in the on position engine off and lights on, does everything light up? If yes good. Then have have the person or yourself step on the brakes and if the passenger side brake light do light up and obviously not ur driver side then its and easy bulb replacement.

The back of the stock radio should have a description of what wires are what to help with replacement. Or you can go to your local parts store and buy a chilton manual for your car, they have wiring diagrams in them.

You can have your transaxle rebuilt for $2000.00 or lessno need to be at a dealer

I would check for voltage at the dimmer switch first.

code B1810 why this reason this code

Ha, what COULD be the problem? Almost anything! I expect you'll find it's just a sensor, though. To find out what is making that light appear, you can usually pop into an auto parts store and they'll hook up the reader to your car and tell you what it says.

I have toyota corolla 2006. Side mirrors are not working anymore. Before I could just them automatically

Vacuum tubing is inexpensive. I would just change the tubing, deposits build up in there. it`s easy and less time consuming. Those lines also become brittle with age,as well. Snip off a piece and take it with you,as there are several different sizes.

What did you plug in? I had a similar issue when I plugged in a high amp tire pump. It kept blowing fuses because the pump itself had a short. Be wary of using stuff like that in the cig lighter. I switched to a hand held pump. How was the computer found to be defective? I wonder if the cig issue shorted the computer?