20 Most Recent 2006 Toyota Camry - Page 3 Questions & Answers

In most cases now there are filters on the pump, in the tank to stop large items from getting in the fuel lines. Then lines then come up to a fuel rail on the engine and go to the injectors. The injectors have small screens in them. There may be a filter on the rail too.

1-6-5-4-3-2 distributor runs clockwise. Except the 3.0 motor is 1-2-3-4-5-6

Pretty rare for an 06 Toyota to need a fuel pump. What were the symptoms that made you think fuel pump and what is the vehicle doing now?

Toyota don't have to many problems with fuel pump.Did you check for sparks?Inspect all the fuses. Scan for codes. Air flow meter boot is week part.The spark plugs is good for 100'K.Replace with DENSO or NGK. post more information for more help good luck

hi there. its usually opposite to the rotation of the engine.which would make it anti clock wise. but it might also have nut lock on it. might be a good idea to warm it slightly some gentle heat from a blow lamp. but dont over do it. good luck

What is the question? The cost? About $900-$1400 in the USA, depending on whether you go to a dealer or use genuine parts or not.

You have blown a fuse likely, but could have also blown out the voltage regulator. I would recommend taking the alternator in first and having it checked. Most parts stores will test it free if you carry it in. Takes 5 minutes.

Check for codes & diagnose the new problem with the VSC Tune-Ups ! --remember those back in the early 1980's, some 25 years ago,your not up to speed,you only get spark plugs

5 post now, and sill in wrong forum. and no engine stated. do we get 6 posts and same? look here in wiki see those enignes. which one?

• 1995 cc VQ20DE V6
• 2988 cc VQ30DE V6

which one, ??????????????????????? http://en.wikipedia.org/wiki/Nissan_Maxima read the FSM. buy one, and read the 58 steps or alldata.com nobody will type out the 58 steps, id bet.

4 posts now to the TOYOTA forum. and not one states the ENGINE option, nobody can help with wrong form , nor engine option in car. open FSM and read. or login to alldata.com and read. you will need to know ENGINE TYPE.

wow a Nissan Camry. what engine, ?????????? what are you doing, we dont know. so.. cam marks? chain marks? spark timing? in 1997, most cars have 6 or more marks. Nissan V6? is it (guessing i am)

• 1995 cc VQ20DE V6
• 2988 cc VQ30DE V6
• 3.0 L VQ30DE-K V6 1999.5?
• 3.5 L VQ35DE V6

if doing major cam work , you will need far more that just mark data. if doing serious work, i recommend the below

1. a real FSM, from NISSAN if Nissan.
2. alldata.com

warning:1 all nissan engines are All Interference so doing cam work or finding engine dead, do a leak down test by hand before cranking engine or bend the valves. after replacing chain, do a cyl. leak down test (a tool) and if it fails, the valves were bent, do not crank engine or the damage WILL cascade $$$$$$$$$$$$$$