2000 Toyota Land Cruiser - Answered Questions & Fixed issues

Question edited for clarity, Maker. Question moved to sub category. With three issue and a buzzing relay, you are best to call out a mobile auto-electrician who can use a Pro Grade scan tool computer to diagnose and fix..

My 1hz land cruiser won't start when its cold glow plug been replace but still can't start after push start than can start easily

Hi I had a car with similar problem. I changed the temperature sensor and problem fixed. Try that first as its cheap to repair. Thanks

Inside the locking mechanism there are switches to supply power for open and close, usually the lever to these switches start to stick and therefore not return enough to operate the switch, I had it the other day a different car but they are all similar, I took the internal door card off, and kept spraying wd40 into the mechanism while operating it manually, it took about 20 minutes, but you could see the lever was not going over far enough, works fine now!!

Please check the owners manual, it is all in there

What gauge jumper cables are you using? May need a larger set. My mustang wouldn't jump on anything more than 6ga.
Are lights coming on at all? Does the engine make any noise when attempting to start?
Could be an elecreical drain somewhere.
Could be a fuel pump. Does it get fuel?
You need more info with your question.

run the fault codes indicates a wiring problem or a TCM problem if there is a bad reading of the speedo , it could be a VSS which reports on road speeds to the TCM

Download the installation manual from the following link DEH 3200UB CD Receiver with iPod Direct Control and USB input

If your after market turbo is blowing oil into the engine, best you have it removed. When you say that fuel may be leaking into the cylinders, it could be leaking fuel injectors. If the smoke out of the tail pipe, it's usually indicator of burning coolant. Blue smoke is indicator of fuel and black of oil.

Check fuses with a continuity tester. Visually looking at a fuse may not give correct status. Also see if circuit is protected by a relay.

put some 2T oil in tank every other full tank ,seems to cure my diesels i have about 2/3 hundred ml will do it .

Ford Idle Air Control Valve Diagnostics High Idle DTC P1506

diesel engine dont know petrol motor ..could be a faulty idle control valve

What year or series is your cruiser?

It all depends on the trailer u plan on towing single axel double axel weight shift no more than 1500 pounds

PDF]STARTING SYSTEM

www.toyota4wd.dk/Teknik/1PZ-1HZ-1HDT/8-ST.pdf Fixed Delay Type (PZJ, HZJ75, HZB and HDB) ex. (Europe and Australia) . ... PlugRelay. To Alternator. Terminal L. Water. Temp. Sensor. Glow. Plug. Resistor. Glow Plug ... HINT: Refer to Diesel Electrical System Diagnosis for inspection ..

Check for codes. Shaking is usually misfire. Is the CEL flashing?

look for this, http://www.allfourx4.com.au/epages/shop.sf/?Locale=en_AU&ObjectPath=/Shops/allfourx4/Products/23380-17411&ViewAction=ViewProductViaPortal&CA_6C15C=720017010000017191

Something in the engine compartment is not working correctly, or is misaligned. The increased friction or misalignment could be causing the belt to fail. Needs to be investigated by a qualified mechanic.