20 Most Recent 1991 Daihatsu Rocky Questions & Answers

http://www.fixya.com/cars/t26394587-firing_order_daihatsu_feroza_2_1994 This post has what you need.

Partstrain.cm

1991 Daihatsu Rocky heater core specs Bing images look under suzuki samauri also they are the same,isuzu trooper too

yes

cam position sensor

transmission just a guess

Your problem will be in your alternator, the brake light and charge light coming on at the same time is almost Daihatsu code for the alternator brushes are failing.. Easiest way to determine this is when the two lights come on, leave the car running and pop the hood (don't forget to put the car in park or out of gear with handbrake on) then find yourself a solid bar or stick and give the alternator (rear of engine bay) a solid but not hard tap. If your alternator brushes are failing you will hear the alternator kick in and see your brake/battery lights go out. Don't drive around too much with the two warning lights lit up because you are running on the battery only and your ignition system could cut out at any time when the battery gets too low.

The starter is located on the right hand side of the engine just behind the motor mount. It is attached with two bolts on the transmission bell housing. There is one large wire to be disconnected and one smaller wire. It is easiest to remove the starter with the battery removed for extra room.

Welcomw ot Fixya

The capacity of the gas tank is 98 liters. Yes you can use other AC parts from other vehicles. But you might need to remount some of the parts like the compressor, evaporator etc..

Thank you for using Fixya! If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b

there should be an adjustable rod on the pedal under dash will need one or two 12mm spaners loosen lock nut screw the rod out of pedal a few turns the try it see if it works its possible the clutch may be worn out and need replacing or may be low on fluid or leaking from slave cyl or master cyl if the adjustment works tighten lock nut and your done