2006 Mini Cooper - Answered Questions & Fixed issues

Did you disconnect the battery are any stage or let it go flat? Security System Reset? You need an auto electrician with a pro grade scan tool computer to diagnose and work out where the issue is.

Check your fuses! Failing that it may be a faulty relay!

i know few error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered within seconds u can get the access and it's totally illustrative complete

Wiring, schematic, electrical diagrams, fuse diag, error codes etc are basic contents of these online books they have here on this website www.reliable-store.com I have attached. Must check it out

Could be blown head or intake gasket or a bad thermostat or clogged radiator or heater core.

You need to see a dealer, no other solution for this.

Sounds like an transmission control module problem I have seen this and often times just replaced the trans mission control module and found everything working properly again.

Sounds like you're going to need an ignition lock cylinder

That would be P1611 and P1613, the letter is important as it indicates the system of the car affected, in this case the powertrain. I would unplug the large connector to the transmission and see if water has intruded into it. if so blow it out until it is dry and reinstall it. If that doesn't fix the problem you need to get a transmission repair shop involved in the diagnosis and repair.

This can be caused by a ignition key interlock fault, the best thing to do is see the dealer for testing.

Susan, check for a blown fuse.

manual or auto matic? manual- clutch cylinder or clutch itself mayb linkages after coming loose of gear selector?

Yes it has been tampered with at some stage if it is malfunctioning in that manner.

Trans may need an update or ajust w that low milage. U can bringit to a private shop. If warranty stil. By federal law dont need the dealr. First chec the fluid leval and cooling lines

Check the list to see what your car has:

bad news bro!!! had the same problem and it was the gearbox, i sent it to gearbox repair shop and it works and it was cheap!!

check all lights including the dash for signal lights working it could be a bulb. if all are working then replace the flasher.

try this site http://new.minimania.com/Mini_Cooper_Gen_II_OBDII_Powertrain_Codes

P-code: P0123 Description: Accelerator pedal position (PWG)sensor A circuit high Threshold value: >4.9 volts Related component: Accelerator pedal position sensor

Should be able to "Pop" case open, case is tightly sealed with o-ring