Top 20
1989 Jaguar XJ6 Questions & Answers
My 89 jag 6 cyl wont rev over 3 k
Him tgus us tii vague a query to fully address, can you give more detail, i.e. pre problem history. Did the issue suddenly appear or has it been coming on slowly? When was the engine last serviced? Could be a fuel system issue, , pump / manifold / injection
Please add as much information as possible and repost the query
Rearend
top up/level plug located on the rear of the axle case,a pig to get to you need half inch square axle key or similar i use a universal joint and bar/ratchet the anti roll bar or stabalizer gets in the way! depending sport suspension or not, the correct oil is shell super 90 or jag. synthetic diff/final drive oil or you could use ep 90
Jaguar subframe bushing tools
Pressed in bushings ?You may have to make something, as you dontwant to buy a special & expensive once in a lifetimetool.Try a rental place for a tool.after you Google somethingthat looks like you need to install them
My Door is Stuck!
You must remove the panel to access the door with the door closed, it is very difficult but i have done it many times. Have a dealer do the job.
Rpms go up and when cold at idle
i dont know about this car but few cars come with automatic choke when you start cold the choke is activated to reduce air intake and in process excessive fuel is drawn in the carburettor to heat the engine and when it reaches the preset point the choke is automatically de activated. if you find it different from before then have a checkup on choke which might get stuck due to malfunction or else
Run but no power
Is it misfiring? Is the engine fuel pressure within specs? Is the exhaust possibly plugged? Have these checked.
Seatbelt on passenger side want
sounds like you have a buckle failure....this is the removal procedure...
- Remove the front seat.
- Disconnect the front safety belt buckle electrical connector.
- Remove the front safety belt buckle.
NOTE: The front safety belt buckle retaining bolt is part of the safety belt buckle and should not be separated.
Installation
- To install, reverse the removal procedure
1989 xj6 will crank over,
Then replace the Engine Control Module (ECM) because the ignition advance checks are ECM Controlled.
Firing order: 1 - 5 - 3 - 6 - 2 - 4
Ignition coil:
Primary resistance = 0,45 ... 0,55 Ohm
Secondary resistance = 5400 ... 6600 Ohm
Not finding what you are looking for?