20 Most Recent 1989 Jaguar XJ6 - Page 2 Questions & Answers

the first thing you should do is check the fuses, if it is ok, maybe the sensors need replaced.---------MVCI 3 IN 1

Pressed in bushings ?You may have to make something, as you dontwant to buy a special & expensive once in a lifetimetool.Try a rental place for a tool.after you Google somethingthat looks like you need to install them

Transmission not done right or ATF low.

check to make sure there is no crack or liquid getting into your distributor cap.

I hate to correct you Guru but on a 89 xj6 the fuel pump is located between the fuel tank and filter under the car. right above rearend. Its a littler hard to see but a easy fix

You must remove the panel to access the door with the door closed, it is very difficult but i have done it many times. Have a dealer do the job.

i dont know about this car but few cars come with automatic choke when you start cold the choke is activated to reduce air intake and in process excessive fuel is drawn in the carburettor to heat the engine and when it reaches the preset point the choke is automatically de activated. if you find it different from before then have a checkup on choke which might get stuck due to malfunction or else

what car is it?possibly a starter motor soleniod :(

change your CPS !

Steel wheel or Mag?1. Steel maybe rusted on.2. Either can be jammed by grit and mud.

Is it misfiring? Is the engine fuel pressure within specs? Is the exhaust possibly plugged? Have these checked.

have the steering rack checked for excess play, also have all the front end bushing checked, this is a common cause of this type of problem, it is the front end that is doing it, finding the worn part(s) is the job that needs to be done to correct this.

there is a fuse box in the arm rest , ck the fuses one is blown ..once you repalce it should remove the circut 3 failure light

wish I could have helped you more. good luck and let me know how it turned out. thanks wally

sounds like you have a buckle failure....this is the removal procedure...

1. Remove the front seat.

1. Disconnect the front safety belt buckle electrical connector.

1. Remove the front safety belt buckle.

NOTE: The front safety belt buckle retaining bolt is part of the safety belt buckle and should not be separated.
Installation

1. To install, reverse the removal procedure