20 Most Recent 1998 Lincoln Mark VIII - Page 4 Questions & Answers

Sounds like an air bag problem. You will not be able to reset the light without fixing the problem. The steering wheel airbag electrical contact is suspect. Airbag will have to be removed and problem repaired. . I do not recommend you repair the problem unless qualified.

BAD WIPER SWITCH

cables are seized and stripped the plastic gears

reset the alarm by getting out of vehicle with the keys ,lock all doors .open car with key retry the starter

usually when a timing chain jumps the car will not run or sputter it just stops as the the ecm continually compares cam sensor and crank sensor readings for timing purposes.your problem sounds more like a fuel pump problem.have the fuel pressure checked with a gauge it should be in the area of 35lbs pressure.if its like 30 then its too low.also replace the fuel filter.

Should be part of the ABS ModuleIf you have a problem, check for codes,google them & read up on the reasons theTrac light would come on

Check fuses, then the relay. Fused power to the lower speeds, and a relay sends power to the fan for high speed. Some cars have an electronic blower motor for a variable speed system. The motor could be bad, or the motor board could be bad, if you have a variable speed blower motor. Very expensive to replace. 250 to 400 dollars. good luck.

Is the blower motor getting power and ground ?

driver's side below dashboard, knee high.

Vacuum Leak?Broken CableBad Motor on Heater Box that controls the Mixing DoorBlocked Radiator Hose

Do you have a "Check Engine" light?Check the coils in each cylinder. At 140k the valve cover gaskets tend to break and oil will fill the coils causing misfires and stalling.

It could be couple problems:-Misfire. (Include bad injector, Coil, spark plug wire)-Lost compression due to broken valves, cylinder wall and head or gasket.Solution:1 -Do compression test.- If not with in specification (Too low) Need rebuild engine due to broken valve, blow out gasket or even broken cylinder wall.-All cylinder has good compression:Now need to check Spark plug, wire and all injector. Injector must be with in specification (In Ohm) Follow its manual.mai Lor

yes theare might be water in it

Remove pan & replace filter,refill,your done

Why ?They seldom failWho tested it & how- to decide itneeded to be replaced?