20 Most Recent 1995 Lincoln Town Car - Page 8 Questions & Answers

Remove the motors and move it where you want then put the motors back in to lock the position. The heavy wires are the seat motors.

First, try swapping the eec relay with a known good unit and see if the problem persists.
Second, you could be experiencing a problem with your ignition module overheating, causing high resistance in the circuit. When the vehicle sits for a while, the circuit cools and will allow the current to flow again.

The switch is inside the door attached to the door latch which actuates it, it just "twists" in place.The switch has a 2 wire connector going to it and it a grounding switch. See picture of door ajar switch below.

what do you mean by repairing manifold?
was it an intake manifolld or exhaust manifold?
either one of them if there is a leak then it would trigger the oxygen sensor, but what is exactly the number of the code? it should start with a po.... some thing.
sound like when engine cold there is a leak then when it hot things got expanded and run better?

yikes--sounds like a freeze plug rusting out/going bad--if your not very handy with cars I would take it in--these are a pain in the @### to change

The flex plate may be cracked and this is causing it to hit the starter drive or other point inside the bell housing. Remove the transmission and replace the flex plate is the likely fix. Have a shop confrinm this guess of mine.

Near the AC compressor down low in the engine comapartment

You have a failed transmission, that will need to berebuilt or replaced with a factory rebuiltNo other fix

check filter if thats not it change fuel pump

remove the fuse either under the dash or under engine hood it will be labeledMake sure thats the only thing that fuse is compatible to.

You can try stop leak, but don't expect great results. If the leak is big enough to lose more than 8 oz in a few days, you have a major leak.And using more than one can of stop leak can cause problems in the system.

You need a special tool to undo the large nut that threads the fan clutch onto the water pump shaft, even with that kit you have a really hard time getting it off if you haven't done it before. Contact Snap-ON tools or MAC tools dealers for the special kit needed. About $100.00

damper stuck

Are you sayin that you can't get it out of park position? If so check the brake lights, do they work?