20 Most Recent
2003 Hyundai Accent - Page 5 Questions & Answers
When i brake i hear a noise what can it be
You may need new brake pads, some pads have a wear indicator that will scrub the edge of the rotor and make noise when they wear to a certain point. I suggest you take to a qualified brake repair shop as soon as possible and have it checked by a professional
I got diagnostic trouble codes P0108,P0121,P0340
Here is what each of your trouble codes means:
DTC P0108 MAP Sensor Range check High
DTC P0121 TPS Circuit Range/Performance Problem
DTC P0340 Camshaft Position Sensor Circuit Malfunction
Do you know how long each of these codes have been stored? Each one of these codes relate to a different part of the vehicle.
Your PO108 codes is probably a faulty Manifold Absolute Pressure Sensor
PO121 is a Throttle Position Sensor malfunction code
PO340 is a Camshaft Position Sensor malfunction code
I would not think that all 3 of these codes all set at the same time, just wouldnt make sense unless there was a problem with the Engine Control Module (ECM) causing all these codes to set at the same time.
Removal of rear seat to replace fuel filter?
You have to remove the back lower seat and gain access to the fuel pump. If you follow the fuel lines coming out from the fuel pump and going towards front of the car, you will be able to locate the fuel filter right on top of the fuel tank, on the right side of the fuel pump access hole
Hi, I own an accent CRDi '03. My problem is
Hi, I think you have a bad altinator or eletrical short which drains your battery over night, once you jump start your vehicle the altinator charges your battery enough that it starts all day but if it is parked for longer time the battery drains.
Replace wiper motor
wiper motor goes on its mount..wiper arms and the wiper hookup can be adjusted a bit.. so they dont go off the window or hit each other while in use..adjust accordingly..
Po735
Had the same problem. Changed the speed sensors on the transmission, and problem went away. Sensors are sold as a pair and are available aftermarket for about $60 CDN
When I turn the key nothing happens. No clicks, no
Ignition switch....the electrical ignition switch. To verify, find the thick white wire in the harness coming from the switch and do two things; first, check for power at this wire, when you switch the key position to start. If nothing, power the wire momentarily with the key in the run position, and your car should start.
Air bag
Need to get it scanned. no clue without codes.
Not finding what you are looking for?