Top 20
1997 Hyundai Elantra - Page 5 Questions & Answers
Cheke engine what dos meen?
Hi,
The check engine light comes on mostly when you have bad gas tank cup,or you don't tight enough the gasoline.Go to any auto-zone and request the obd scanner,at no charge just leave your driver license or credit card,connect the scanner follow the instructions.They will check up and the check engine light will come off in the next 3 to 5 days.
Thank you !!
Correct torque on cylinder head bolts for Hyundai Elantra 1.8GLS
You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM
Battery holder
Hi my name is Tom and I am here to help
I have never had any luck with O.E.M. battery holders. I never wanted the pay a dealer for this kind of item.
I have had luck with generic holders. I worked at an auto warehouse and used one we supplied to many auto stores. You may have to do some modifications but I think that is your best bet.
If I can be of any further help let me know. Either way please let me know if I was any help by ranking me in thumbs up.
TomE
L/B green signal - Hyundai Verna 1999
I have the same problem with my elantra 1999 you should check oxygen sensor or replace it but before that cut the yellow from the oxygen sensor if the problem gone then replace it else i dont know but try
I have a 1997 hyundai elantra and i have three
P0422 - Catalyst below threshold.
Catalytic converter is clogged or out of medium.
Replace it.
ACTUAL DIAGNOSTIC:
Fault Code Definition
Code P0422 indicates that the Bank 1 Main Catalytic Converter's
emissions efficiency has fallen below the minimum allowable limit. This
threshold is tracked by a Catalyst Monitoring Oxygen Sensor located on
or near the outlet of the Catalytic Converter.
Symptoms
* Check Engine Light will illuminate
* In many cases, no abnormal symptoms may be noticed
Common Problems That Trigger the P0422 Code
* Defective Catalytic Converter
* Engine misfires have damaged the Catalytic Converter
* Internal engine damage resulting in high oil consumption and/or a leaking Head gasket has damaged the Catalytic Converter
Common Misdiagnoses
* Oxygen Sensors are replaced when the real problem is a damaged Catalyst
* Catalyst is replaced when the real problem is internal engine damage, which is producing elevated emissions levels
* Catalyst is replaced when a misfiring engine is the real problem
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.#$@!
How do I remove the
hello. do this:
On manual window regulator equipped models remove the window crank handle.A shop towel worked up between the handle and door panel will usually dislodge the clip but it can also be removed with a hooked tool
- Remove the outside mirror
- Detach the door handle trim piece and disconnect the linkage rod.Remove the door pull mounting screw.Unplug the electrical connector from the power window switch
- Remove the retaining screws and detach the panel by carefully prying it away from the door
My hyndai elentra 1.6GLS needs a new clutch kit
Autozone, they can usualy order what ever you need but the best bet is if you can find an Autozone hub store they have thousands more parts than the small ones. and as a note no matter what they tell you, unless they look in the book and cant find it then they can get it. although spiromobile in downers grove IL can get it too they have all kinds of odd parts, if you cant find the number just call the autozone on ogden av in downers grove and they can give you the number. spiro will also ship the part to you if you require.
Is it ok to have a 15inch wheel on avante 1997
it is OK as long as the tire will match the original diameter, if the tire is taller or shorter it will cause shift problems if it's automatic and will cause the fuel ratio to be off and will cause it to use more fuel unless you change out the computer chip to match the tires, since tires revolutions are counted by speed sensors it's going to cause you some issues.
I need the cylinder head torque settings for 1997
1998 Hyundai Lantra "G4GM" engine 1795cc.there are two heads or blocks, one is called the M10, other is the M12, figure out which one you have cause the torque is different for stage one by 5nm...........
Dont get confused theres 2 different engines so 2 different torques for stage1---------
heres the full details: Stage 1 - m10 = 30nm / m12 = 35nm-------------------------- -------- Stage 2 - tighten by 60-65 degrees ------------ stage 3 - tighten by 60-65 degrees. no sequence is given in the data book for tightening so go off what you thinks right, it doesn't matter on this engine.
Not finding what you are looking for?