20 Most Recent
1997 Hyundai Elantra - Page 9 Questions & Answers
1.8 Lantra 98 - No Spark
An idea is to check any wiring going behind the engine. If you have wires laying against that area, there is a really good possibility that there is a burnt wire or two. It happened on my Startus and I replaced everything you did, only to take it to a garage and they spliced them together...7 cent splices, $89 an hour...$234 later....I had my car back.....but same symptoms as yours.
Passenger window wont work master only brings it
It could be the switch, or the regulator. You'll need to remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. If needed, you can pull back the weather
seal
(can't reuse it, but it's not that important) and you will be able to
access everything inside the door
Car on occassion over heats. Has coolant in it,
Like when you say it over heats how hot are you talking? And the next cheapest item to do is if you think it is the Thermostat, change it. Are you loosing antifreeze or have you had to add any?
Screeching noise
dear friend-the fact that your car did not switch of for 10 sec means that the fuel did not cut when the ignition was switched of.i think you must have it checked.
Just changed waterpump in our 1997 Elantra, has
check the oil stick if their is a milky like substance on it if so the the block could be cracked. i hope not. The mechanic should've notice this if thats the problem. do check plug also. H.I.W.H
Question re Hyudai Lantra 1997
This could be a lot of things. The 'check engine' light is only an indication that somethign is wrong. this usually only means that a sensor that determines how the car will rn is broken, wore out, or lost connection. I would take it by a shop.
what they will do is plug your car into a computer ( that costs thousands) and the computer will give them a code that will give hints to what happened and what needs attention.
if the light is only on sometimes then it's just a connection but on all the tiem you need a new sensor somewhere. hope this helps
Break lights on hyundai elantra wont switch off
The switch that controls this is attached to your brake pedal itself. You'll have to lay on the floor, looking up under your dash and you'll see a couple of wires attached to the switch that is attached to the pedal. Spray some WD40 all around that switch, pump the pedal a few times and all should be well.
KEY WONT TURN.
have tried to steer it a little while you turning the key? because some the steering lock was stuck.
Torque wrench settings for 97 hyundai lantra 1.8
They use throw away bolts. One use only, so don't reuse your old ones. You will need new ones. The smaller bolts 1st torque setting 22Ft/Lbs and the larger 26ft/lbs, the 2nd torque setting 60 degrees both bolt sizes and the 60 degrees for the third.
Not finding what you are looking for?