20 Most Recent
1992 Hyundai Excel - Page 6 Questions & Answers
Where do i find the
If you look at your 8th digit in your VIN or Vehicle Identification number.. (counting from the left) this will tell you your engine type for the vehicle. You can use this number to look online, a local parts house can tell you or.. You can shoot me a message back with the number and I will send you the info..
Best of Luck to you..
Fuse box Hyundai excel 93
DIY? you need a repair manual from your auto parts store, or filepeep.com if they have it , or manualslib.com
Where is the reverse light switch on a 97 hyundai excel
Typically, reverse light switches are located under the dashboard. They work like a refrigerator light switch that is pushed in when the door is closed and as soon as the button is allowed to come out the light comes on.
In a car, the same kind of switch is operated by the upper end of the brake pedal arm up under the dashboard.
Check your fuses also. They're more likely to go than the switch.
Can I take out and
its a good idea to just call a glazier, usually the installation is included in the cost and they guarantee the window for up to 2 years from leaks and some types of crack damage.
If you still are decided on going hte self installation route you will need the following tools;
Glazier's knife
Flat head screw driver
Philips head screwdriver.
RTV compound or some kind of window adhesive
1/4in. socket set with driver
the process.
1. remove the windshield wiper arms.
2. remove window trims around the windshield
3. using the glazier's knife cut the old window adhesive around the windshield.
4. clean the adhesive off the windshield perch (that is the area around the windshield on the car)
5. carefully apply new adhesive to the windshield perch.
6. set the new windshield in place and press firmly around the borders of the new windshield you can tell when the windshield is set by the 'squished down' appearance of the adhesive.
7. replace the window trim and wiper arms. allow the adhesive to set for a few hours before allowing the windshield to take on water.
8. not necessary but i like to do this confirm the windshield does not leak by allowing a hose to run freely over the windshield.
***BE WARNED THE EDGES OF TEH WINDOWS ARE SHARP AND CAN CUT YOU VERY SEVERELY, ALSO THE GLAZIER'S KNOW IS SHARP AS WELL***
Over revving
I had similar problem on 98 Taurus. The plastic housing from air filter to Throttle body had crack on bottom, could not see from above...car would over rev sometimes, then almost stall, Replaced it, with good one from junkyard. Runs smooth again. Crack came from shoving that housing out of way from putting in new thermostat earlier.
Not finding what you are looking for?