Hyundai Motor 1992 Elantra - Answered Questions & Fixed issues

I think power for this comes from ECU, so might try disconnecting battery, then ECU plug and spray with contact cleaner and reconnect. If no help, you must trace the wiring to look for break, but first insure the ECU is getting power. In fact, first check all fuses. Is everything else getting power?

Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop & owner manuals, service bulletins, campaigns, illustrations and procedures, etc

Have you check fuel for fuel pump,fuel pump relay?

have you checked for spark and if not start there check the plugs and if there good check the coil

just reset the ecu..... go to a nearest hyundai car service,

There are two ways to find the Exact Value Adjustment.

1. Valve adjustments are usually labeled on a sticker in the engine bay.

2. Valve adjustment will also be mentioned in the user manual, if you don't have ask your nearest Hundai service center for details.

As it is a very old version, i have scraped the data.

Thank you

Check the starter relay.

Has similar problem, just got back from the shop and they said it's the neutral safety switch.

Tip on starting even with a broken switch:
1.) Turn the key all the way to start position (you will hear the gas pump humming and all the lights should be on)
2.) press the clutch pedal all the way down (if it starts, then it's fine, if not, proceed to step 3)
3.) release the pedal slowly and just slightly (an inch or so).
-->on the first try, you should hear a slight click and feel the car moving slightly. That's the point where the car tried to start.
4.) Repeat step 3 for several times if the car doesn't start until you are able to grasp that exact point and once you hear that click, hold the clutch at that point and the engine should fire away.

Of course this is just for temporary counter measure, I have to do this because this is my commuter car and I got to find a way to have a reliable and predictable start. Hope this helps.

having the same problem. If you found a solution please post :) thnx!

undo the fluid line onthe old one .the removeit attatch thefluid line to the new one before bolting it in place ,make sure the master cylinder is full of fluid be fore undoing the bleed screw a couple of turns,it will gravity bleed itself ,just keep you eye on the fluid in master cyl, as soon as clear fluid cmes out the slve cyinder do up the blld screw and the job is done..NOW i have to ask this ,i cant help my self, what makes you think it is the slave cyl that is at fault? i see people change them quite often and the problem ,more often than not is in the master cyl. good luck

motor oil in the combustion chambers[where the spark plugs are] is NOT NORMAL it is evidence of failure of valve seals and/or worn piston rings,requiring major motor repair.try to return it & get your money back,or at least a credit towards repair.

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

no, leaking water pump just means it is time to replace your pump. Not continue driving until you get around to it. replace it now. If it is not starting something esle is wrong. Unless you've over-heated the engine.

When you run a car out of gas,all the dirt and debris from the bottom of the tank is sucked into the lines,First replace the filter and flush the lines if needed.

don't chance a engine failure...you ca get timing belt info at the public libuary.  Haynes or Chilton Manuals

Check the position of the wires with the coil, some coil in Hyundai have number 1,4,3,2 these number are the cylinder, in the motor the cylinder number 1 is the first of the left if you are in front of the hood, and check the spark gap to 1.0-1.1mm

the fuel pump is located inside the fuel tank

I can locate one in new zealand relatively cheap for you but that probably isnt too much help. Try EBAY and see if you can find one there. Failing that I would contact a local auto wrecker to see if they have one or can get one.

Let me know how you got on

Cheers

Question edited for clarity, correct spelling of model. Question moved to model category. It could be so many things. Find a local auto-electrician, a professional grade scan tool computer will diagnose all the electronics computers, modules and sensors in 30 minutes. https://www.google.com/search?q=auto+electrician+near+me ..

some cars the dash has autodimmer a sun sensor on the dash some can be disabled , so read the users guide to do that. most cars, we can disable the out dim in the free users guide, search word DIM. bingo,? see on,off ,up ,down or auto?> find the top of dash sun sensor shine a very bright light there, and dash DIM goes full bright, if yes, bingo see the users guide in the glove box yet page 5-42 is your answer see the words obstructs either sensor bingo it is in your manual this. https://www.carmanualsonline.info/hyundai-elantra-2022-owners-manual/?srch=dim