20 Most Recent 1997 Saturn SL - Page 5 Questions & Answers

HOW MANY MILES ON VEHICLE? I WOULD FIRST REPLACE TRANSMISSION FILTER, FLUID, AND GASKET. MAKE SURE TO THOROUGHLY CLEAN ANY METAL DEBRIS FROM MAGNET LOCATED IN BOTTOM OF TRANS PAN.DO THIS AS MAINTENANCE, AND ALSO CHECK SHIFT CABLE/LINKAGE ADJUSTMENT PER SHOP MANUAL

Should be in the fuel line under the car.

you can remove the fitting and put teflon tape on it but use the teflon for lp gas It should be the yellow roll not the blue,.

Did you notice a change? I have a car like this and 1st gear is quick. There is not a lot of power.

What do you mean "missing?"

RUN THE AMP/OHM DIAGNOSTICS ON THE MODULE. CHECK FOR SPARK. REPLACE MODULE IF IT;S 5 YEARS + OLD SIMPLE!

of course!...however you do not want to bypass this safety switch! bypassing it will allow a car in gear to start...possibly running over and/or killing someone! get a cheap switch at a salvage yard!

have you replaced the fuel filter?

check relays in the fuse either stiky or sized

Fel pressure regulator is bad, I'm sure. When you Turn off the car, pressure remains in the injector rail. The diaphram in the regulator allows that pressure to enter the engine through the vacuum line that controls it, and floods the engine. I am 99.9% sure this is your problem

whats the problem??

although the picture is of a 6 cly model the location is the same HO2 sensors are mounted in the exhaust system before and after the catalyst HO2..1 is the up stream Before the cat and HO2...2 is down stream of the cat if your code is bank one sensor 1 its the upstream and bank one sensor 2 is the downstream

Your flasher needs changing.Here's what it looks like.The Flasher is located:Seating area, center, under dash, mounted under center of dash

the idle is controlled by the computer system these new cars are not like the old days when u could spin ur distributer and adjust ur carbarator so without ne other info on ur problem this is all i can say