20 Most Recent 1994 Land Rover Discovery - Page 9 Questions & Answers

No year. If it electric, replace the motor. It has a module built in it. If it is manual. Rebuild the T case.

I'd probably have to double check your temp gage and go from there. What all did you replace? Other than your temp gage, any indications of overheating, like the engine smoking or coolant boiling over. Are you losing coolant? Does the radiator fan work? Did you check for coolant circulation. Check for combustion gases in the coolant. How hot does it get in degrees F?

I'm guessing you do not require help anymore..
Anyways.. The sound d could stop when the brake pads are changed.

If the fuse is OK as you say, it is most likely the switch, a broken electrical line or the drive motor. Try chasing the cable from the switch to the motor and check for 12+ volts at various points with the switch in the "on" position.

Hello, The fuse panel for the radio & windows is located under the panel just below the steering wheel! Please use the following link to locate what you need; http://ww2.justanswer.com/uploads/jettadan1/2010-09-25_053547_fusesss.pdf Good Luck! Rich Lilja

might be worth a shot...

It does not have 1 You can check the oil level when you turn the ignition on , Press the state button no foot on brake and scroll through the menu till you find it.

You need a diagnostic scan to find a fault code to help with repair. Good local garage can help...most likely an abs / sensor fault.

For Land Rover codes etc. Go to: GB4x4Radios.com

have you tried removing the light via the OBD system ie clear the faults

It is on the end of the air filter box.

Sounds like your throttle body is dirty/plugged.

Make sure your brake light are 'really' coming on when you press the brake. You can also take the plastic housing, around the shifter handle, up and using a screwdriver move the locking pin out of the shifter shaft.

Check fuses.

Why do you need to know? Unless there is an immobiliser fitted, there is no relay as such - starting is controlled by the solenoid (the small cylinder) attached directly to the starter motor.

Hi,try putting a stop leak additive in the power-steering-pump reservare to stop the leak,and the screeching could be comeing from the belt that runs the power-steering-pump-pully.(It sounds like it might be slipping so will need adjusted). Hope this was some help.

You will need to have the brakes serviced. The hand brake is the parking brake and uses a different set of shoes to stop the vehicle. It may have nothing to do with normal braking. But you need to have parking brake shoes replaced.

Children or Haynes normally do these. Approx 30 pounds or 50 bucks

In what? How about more info? We are all stumped. What make. model, etc. LOTS more information required to begin to answer