20 Most Recent 2002 Porsche 911 Questions & Answers

0helpful
1answer

911 rear spoiler not closing

Adjust the spring located under the lid in the middle, just lower it n see if it latches. ( assuming your latch on the body side is working, it should be very hard to push it open. )
12/15/2014 5:09:09 AM • 2002 Porsche 911 • Answered on Dec 15, 2014
0helpful
2answers

Malfuntioning driver's side power window upon opening door lever.

get it to the dealer asap.

you definitely need to take apart the door. There's something not right inside.
10/2/2014 9:48:11 PM • 2002 Porsche 911 • Answered on Oct 02, 2014
0helpful
1answer

Left front trun signal does not work blinker goes fast changed the bulb but that did not work

Did you verify that both turn signal bulbs were working on that side of the car? If so you may need to replace the turn signal flasher.
3/19/2014 11:38:28 PM • 2002 Porsche 911 • Answered on Mar 19, 2014
0helpful
1answer

How do I access the evaporator drain line?

Hook a Wet/Dry vac (with the filter removed) to the outside drain line. This will allow you to suck the drain line clean and remove any water/algae/debris from the line. As a maintenance item, you may want to pour 1/2 c of household bleach into the drain line downstream of the drip pan to minimize the future growth of algae. Do both of these items yearly to keep problems from recurring.www.lightdeal.co.uk
5/28/2013 9:33:48 AM • 2002 Porsche 911 • Answered on May 28, 2013
0helpful
1answer

Where can I get a fuse box diagram for 2002 Carrera 4s

he codes are: P0172 System too rich Bank 1 P0175 System too rich Bank 2 P1443 Small or no Purge Flow ConditionThe first thing to do is to check the fuel pressure. If it is too high, it will cause the engine to run rich. You may have a bad fuel pressure regulator.
5/25/2013 4:26:33 AM • 2002 Porsche 911 • Answered on May 25, 2013
0helpful
1answer

Replace the switch that controls the soft top

Pull out the 2 oval covers for the interior motion detector and behind them you will see 2 torx screws, remove the screws. Then pull the top latch housing away and disconnect the electrical connector.----------

The switch is held in place with 2 round clips. Pry the clips off and then the switch comes off. You cannot reuse the clips so buy them when you buy the switch.-------
See the image of clips.The 2 clips that hold the switch in place. helpmech_122.jpg
--------- This will help.Thanks.Helpmech./
4/25/2013 4:20:55 PM • 2002 Porsche 911 • Answered on Apr 25, 2013
0helpful
1answer

Rewire power window porsche 911

start by looking at the place where the wiring goes from body to door in the opening, repair that wire or forever have issues
3/11/2013 4:38:04 AM • 2002 Porsche 911 • Answered on Mar 11, 2013
0helpful
1answer

How reliable is porsche 911 996 engine

hello thereJust the engine or the whole car?If you keep the oil and water in it ,it is very good.proporsche
3/3/2013 9:29:34 AM • 2002 Porsche 911 • Answered on Mar 03, 2013
0helpful
3answers

Oil mixed with water in coolant

Head gasket would be your only problem, the oil cooler normally is cooled by air and not water.
2/17/2013 3:37:21 AM • 2002 Porsche 911 • Answered on Feb 17, 2013
Not finding what you are looking for?
2002 Porsche 911 Logo

137 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2004 Porsche 911
2004 Porsche 911

37 Questions

1991 Porsche 911
1991 Porsche 911

28 Questions

1995 Porsche 911
1995 Porsche 911

26 Questions

2005 Porsche 911
2005 Porsche 911

25 Questions

1997 Porsche 911
1997 Porsche 911

24 Questions

Top Porsche Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

911 Porsche

  • 911 Porsche

Most Popular Question

rewire power window porsche 911

  • Cars & Trucks
Loading...