Top 20
1997 Jaguar XJ6 Questions & Answers
Hi!
My friend has got a
i assume your car is@1997 a model/year x300 a common cause of the symptom you have is a corroded/open circuit wiring at a connector or around under the washer bottle filler white connector i think its the ok to start signal from the security/locking module located below trunk fuse box the module can also go faulty. one easy test is to switch ign on if the check engine light goes off with other warning lights. start there fault finding with the wiring etc
Driver door will not open from inside
remove the door trim and reposition the pull rod from the handle to the lock mechanism There is a small plastic lock bit that holds the rod in the latch hole and they break off allowing the rod to fall out.
Ignition lock cylinder removal xj6 1997
To remove the ING barrel put the key in turn to position one.on the side of the colum round the barrel there is a hole you need to press the button down that is in this hole. If the key is not in or in the wrong position the barrel will not pull out.
No spark no injector pulse
crank sensor most likeley cause of prob, located above front of crank pulley. but check ignition supply to injectors/ign system.
How to change spark plugs?
Spark plugs to be unscrewed properly and carefully out of place , and to make sure when you put back that it is done properly and in place slowly and easy by hand to make sure that you are doing it as per the threads in the engine , if threads go bad you will have a big problem to correct.
If the plugs have oil on them from the spark end , means the engine is kicking oil to the plugs and that could mean that the piston rings are weak.
You could always use the proper tools as attached to pull the plugs out
Starts dies
Dirty throttle body and relurn after cleaning , fuel filter , air filter, fuel pump ?
Po158 po159
After cat oxygen sensor fault.
Check wiring and sensors.
Not finding what you are looking for?