20 Most Recent 1985 Jaguar XJ6 Questions & Answers


Check that the wiring and terminals to the sender unit are not broken or dirty. If they are good maybe the sender unit it self is not working.

1985 Jaguar XJ6 | Answered on Jun 07, 2015


The horns themselves, as well as the electrical relays, can often be replaced with a standard ones from one of the auto parts stores. If parts are not available for the horn switch, An different switch, again from the parts store, can be installed or one obtained for a salvage yard.

1985 Jaguar XJ6 | Answered on Jun 05, 2015


i need a diagram of a series 11 xj6 jaguar door i.e. the position of the electric window into the door as i cant line the bolts and frame up. need to see a picture of it. thanks

1985 Jaguar XJ6 | Answered on May 29, 2015


There are a couple of possibilities. The brake lights only operate when the ignition is switched on. If that is not the solution then I suggest that you may have dislodged a connector when changing the brake components you mention. I have never had this problem and until I get my service manual back from the local garage I cannot tell you where to look for the pressure switch. It should be close to the master brake cylinder.

1985 Jaguar XJ6 | Answered on Feb 19, 2015


The manual handbrake is cable operated. If it has been adusted regularly during the 30 years of operation, it will probably not have any adjustment capability left. The adjustment is by use of an adjustment screw that you will see under the car. My car is a 1983 Jaguar and it has this problem. I am unable to obtain a replacement cable at present and am considering getting my mechanic to shorten the existing cable. I rely on the transmission parking lock to hold the car when parked.

1985 Jaguar XJ6 | Answered on Dec 18, 2014


It needs to be grounded to some metal part on the car. If the mount is rusted or broken you can drill a hole on the horn its self and attach a wire to it using a metal screw then attach the other end to something metal on the car.

1985 Jaguar XJ6 | Answered on Jun 11, 2014


It could be the reverse brake band. If you get a Haynes manual for this model, it will tell you where and how to adjust the bands.
Hope this helps

1985 Jaguar XJ6 | Answered on Feb 11, 2014


put a radiator flush in your expansion bottle run it for about 20 miles to clean out both the core of the radiator and your heater core .then drain it. refill with 50/50 mix of anti freeze. leave off the cap the now as you need to bleed it first. to do so .put your heating on full with the engine ticking over .the water starting to heat up put on your cap.

1985 Jaguar XJ6 | Answered on Dec 11, 2013


There should be a notch cut into the distributor body to mark #1. If you can't find it then turn the engine over until your timing marks are lined up.You will need to lift the valve cover to check that as you move past the timing mark or TDC that the exhaust valve starts to open. If not then rotate the engine 180 Degrees and try again.

1985 Jaguar XJ6 | Answered on Nov 17, 2013


PASS SIDE OF MOTOR IN THE REAR BOTTOM OF ENGINE COMPARTMENT.

1985 Jaguar XJ6 | Answered on Nov 15, 2013


153624 no. 1 at front if its aj6 engine no 1 at rear if its the old xk ie series3

1985 Jaguar XJ6 | Answered on Nov 13, 2013


It sounds like insufficient fuel pressure.

1985 Jaguar XJ6 | Answered on Oct 26, 2013


FUEL PUMP SETS DOWN INSIDE THE CENTER OF THE BIG FUEL TANK.FUEL TANK HAS TO DROPPED DOWN TO REMOVE FUEL PUMP.

1985 Jaguar XJ6 | Answered on Oct 26, 2013


Welcome to Fixya

Check the battery cables to make sure the hookups are not corroded. Corrosion can put a damper of the flow of electrical current and can be the entire problem. Check all terminals if they are both intact and not loose. A simple way to tell if the battery is at fault is to turn the headlights on and turn the ignition switch to start. If the lights go out, then the battery is probably at fault.
If everything looks okay, the problem may be the solenoid. The solenoid is essentially a switch that turns the starter on and off. When your car is just sitting off in the driveway, the solenoid is receiving a current from the battery, but it does not pass it on to the starter. When you flip the ignition, a small current signals the solenoid to let the current through to the starter. The starter then turns over. When you have a solenoid that is going bad, the switch can get tweaked and not let the current through correctly. Since the electrical current isn't enough to fire up the starter, the engine doesn't fire. In some cars, it just makes a click noise. Thank you for using Fixya!

If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b

1985 Jaguar XJ6 | Answered on Oct 26, 2013


Hello, friend. if your speedometer do not work, why not have a try of odometer tool.

1985 Jaguar XJ6 | Answered on Aug 31, 2012


You would need to find out if the system has been converted to R134 or if it is still using R12.
If R12 you would need to have a licensed tech do it, or have someone convert it to R134.

1985 Jaguar XJ6 | Answered on Aug 31, 2012

Not finding what you are looking for?
Cars & Trucks Logo

128 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1995 Jaguar XJ6
1995 Jaguar XJ6

570 Questions

1994 Jaguar XJ6
1994 Jaguar XJ6

369 Questions

1993 Jaguar XJ6
1993 Jaguar XJ6

-55 Questions

1990 Jaguar XJ6
1990 Jaguar XJ6

-64 Questions

1991 Jaguar XJ6
1991 Jaguar XJ6

126 Questions

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

XJ6 Jaguar

  • XJ6 Jaguar

Most Popular Question

distributor firing order

  • Cars & Trucks
Loading...