20 Most Recent 1998 Land Rover Discovery - Page 4 Questions & Answers

Did you bleed the clutch once you had changed the slave cylinder? If not you will need to do this to get any pedal.

1. Pull out side facing seat or pocket cover.2. Unscrew fastener and remove access panel.3. Turn bulb holder anti-clockwise to release.4. Remove bulb.Refitting is reverse of the above procedure

it sounds like your left tail light bulb is burnt out

Yes, the brake switch activates all brake lights. Judging by the age of your vehicle it could well be a ground problem. Try unscrewing your tail light screws and clean up any rust you see before screwing them back in. If you dip the point of each screw in Vaseline it will protect against further rust. Also try following the wiring when it comes out of the harness to see if there's a break or disconnect. Putting a stick between the bottom of the dash and against the brake pedal will let you know if you hit paydirt while you're working as ignition does not have to be on to activate brake lights.

excessive noise from lower bellhousing. remove four torque converter bolts and start and run motor....if noise change then maybe flexplate

Have you had the tracking checked, and wheels checked ???

Check your fan control switch. Maybe invest in a new one.

Check your head gasket. Also check your water pump.

I have a 1998 Disco I and I have the same problem. This weekend, June 29, 2013 my car overheated while driving up a maze in a parking garage to the guest parking. All of a sudden my temperature went way high but not quite at the redline. By the time I got to the seventh level and turned off the care, the radiator spewed fluid everywhere. The next morning I drove it home (3 miles) and it did not overheat. I filled the radiator with water and there is no obvious leak. I don't know what to do and I have been driving here and there with no problem and no overheating !!!!?????

There is a valve that may be stuck closed causing insufficient coolant to cool engine down

Make sure your 4wd shifter is in correct position and hasn\'t slipped out. I had that problem and pulled my hair out for a day until I found that something bumped the stick out of its normal spot.

your brake switch is broken, its on the top of brake peddle. It wont shift from park because you need to press brake to shift from park and with the switch not working it doesn't know your pressing the brake. check connection on switch if its fine you need to replace.

your brake light switch at the pedal deeds to be adjusted or more likely, replaced

Find a air reset tool for your car ,but ,before you buy it ,you should know the year of your car ,i know this website ,you can to to see it www.drsets.com